Find an experienced handyman in Roseville

Looking for someone experienced with door hardware to spec up our internal door handles so I can order replacements. One handle has already failed and come apart, so this needs doing. All our doors use the same builder hardware, so it's really one measure-up plus a count: - Measure one door for the specs I need to order: backset, door thickness, spindle size, rose/backplate size - Walk through and confirm the count and type — passage vs privacy/lock vs any keyed doors (roughly 12 sets total) - Give me a simple written list I can hand to the shop so I order the exact right parts I'll buy the hardware myself once I have your list. **Install will be a second booking with you** once the sets arrive — happy to agree that price on the day so you've got the full job locked in. Please only apply if you've fitted door hardware before and can spot fit issues before I order — I don't want to buy 12 sets and find they don't fit. Photos of the current setup attached

Need suspended gyprock bulkhead installed over ovens to capture heat. L shaped about 4m long and 1.5 m deep and 1m drop. Also some small patching.

We have 4 Roman blinds that have been installed recently in a bedroom that have a manual chain operation. The blinds were purchased from Tuiss (Blinds Online). We have 4 motors that have come off the previous blinds that need to be put on the new ones to convert them. Requires someone who is familiar with these specific types of blinds and can confidently install and get them working correctly.

I need a ceiling fan installed. 3.2m ceiling.

Looking to have a Jetmaster i30-x installed. Fireplace will need to be widened to make room (about 20cm). Gas point is just to the right of the fireplace and there is currently a PowerPoint behind the TV about 1m from fireplace (right side). Scope of works to include clean demo to remove minimal brick, electrical work, plumbing to adjacent gas point and running flume up chimney. Please quote price

Looking for a professional plasterer to properly: • Cut out existing damaged/uneven ceiling patch • Re-sheet with new gyprock/plasterboard • Feather joints correctly • Sand smooth ready for painting Need a professional smooth ceiling finish with no visible patch lines.

Bedroom door won't close properly — it's catching/binding on the latch edge and needs trimming or planing to fit correctly. Looking for someone to: • Identify exactly where the door is binding • Plane or trim the edge so it closes smoothly • Seal/repaint the trimmed edge to prevent it swelling again. Please bring your own tools.

Change capacitor on an existing fan as it is running very slow.

This heating & Cooling is through floor system. the pipes are under the house.

We had a power outage and treadmill won’t turn on

Replace 2 AC ceiling fan to 2 DC fans Also replace the 2 analogue wall fan speed controller to simple on/off switch. Ceiling is 2.7m high. Licensed electrician required

Dog installation into metal screen door. Have already purchased the dog door

I would appreciate an opinion on our front flyscreen door - could it be possible to save it and if so much much to put on a new screen and remove rust with paint touchup?

There is a blockage in the Kitchen sink drain pipe and causing the water to seep in slowly

Supply and install suspended furring channel ceiling lined with 13mm plasterboard as per plans

Clean 6 ceiling fans in our home. High ceilings so will need a ladder

shower screen or cubical in an two bedroom apartment

Bathroom door has a big hole in it and the door handle fell off. Need to have it removed and ideally disposed of and new door that looks the same installed.

Paint outdoor window frames.Need high ladder

I have four Roman blinds to hang in bedrooms. They need to be attached into gyprock walls (one might be masonry). Must have own tools. Late notice but would like the Rak done tomorrow if possible as I’ve just given away the existing blinds 🙈 Blinds come with all fixtures, you just need a drill, I have a ladder or you can bring yours. Thanks! 🙏