Find experienced local fencing contractors in Elwood

Damaged by car need to be fixed. The timber at the corner is damaged and now rotted, so it needs to be replaced with new timber.

Fix falling fence need wood post to support

* Deadline: Today ideally * Install 7.5 pieces of trellice/lattice to fence (as pictured) * You need tools and galvanised nails * One piece needs cutting to size * Easy access

Repair of wooden fence panels on fence. I think these can be fixed without total replacement. I have the paint to paint over repairs so anything to fill/repair the broken bits is ok.

Fence post needs straightening up and resetting with Concrete. The post is a 100 x 100 mm steel post cladding timber and has been hit by a car and dislodged needs to be reinstated and pulled straight possibly with a winch or car and strap then reset with Concrete. 

Fence on a lean may need access to neighbours

Replace fence which is old and not in a good condition. It is approximately 11.7 metres but will require a more accurate measurement.

It’s a Corp building I am owner occupier Looking for quotes to replace part of front fence that was removed to repair water pipes Height appx 70cm Width appx 24cm Length appx 270cm Can attach pics

Remove 4 posts bolted to fence (without damaging fence)

Build and install 3 metal frame gates Back gate 760mm wide - lock Side gate 870 wide pool latch Hallway gate 920wide pool latch

Replace existing pailing for a taller one. New one will be 2 meters height. Also install lock on the gate.

Repair existing metal gate - new post to be concreted in and new lock to be aligned

22M of fence needs replacement.

I'm looking for someone who can install a section of boundary fencing that replicates what has been erected previously. the section in question is 6.5m long and would comprise a post and paling fence 2.3m high - this includes 2.1m long palings and 2 x 100mm high timbers along the bottom. Existing timber sizes are as follows : rails - 50 × 70 × 4No. posts - 120 × 70 (length to suit 2.3m high fence) palings - 140mm wide palings plinth boards - 2x 100mm high include black paint

Build a standard wood paling fence between two properties. Length 29M, at 2.1M height , the last 6M beside driveway at half height. Need to supply all the materials.

The gate post is too far from the gate and I need a 19mm timber fastened onto the post and have the gate catch that needs to be recessed into the timber.

We would like someone to take down our old fence (discard it) and build the same fence (replace like for like). The fence is approximately 5.28m in length and 1.6m from the ground (you will need to provide materials which will be included in the quote). You can see the length of the fence in the picture. Access is easy. no neighbours to worry about and there is plenty of clearance.

Need fence pailings on outside of fence

Old timber fence to be replaced with new Fence to be dismantled and left on site Fence runs between two properties

I’m looking for someone who can install a section of boundary fencing that replicates what has been erected previously. the section in question is 6.5m long and would comprise a post and paling fence 2.3m high - this includes 2.1m long palings and 2 x 100mm high timbers along the bottom. Existing timber sizes are as follows : rails - 50 x 70 x 4No. posts - 120 x 70 (length to suit 2.3m high fence) palings - 140mm wide palings plinth boards - 2 x 100mm high include black paint