Find trusted local electricians in Inner South Melbourne

Need an extra power point added in my kitchen There is a PowerPoint below for my microwave we can use to add from- see photo Would like new PowerPoint to be located near the vase

Need an electrician to install 6 outdoor wall lights on weatherboard walls. The lights will go either side of my windows. There is only 1 spot with light fittings, others don't have power right now, so you'll need to run new wiring to 5 points and wire in each light.

Need help recessing a plug , installing a new plug, moving an antenna connection for a tv install

Advised on this site to clean gas jet ignition but this has not worked as it seems to be electrical fault. Now it has triggered internet failure according to my provider. Two jets currently clicking constantly.

I have x2 ceiling downlight's which need replacing. I do not have replacement globes as they are not easily sourced. They are not LED -images for context. *Budget is negotiable

1. Install 2 sensors in 2 bathrooms 2. Install a PowerPoint 3.relocate power to tv area 4. Extra lights outside and extra garden lights and add some sensors 5 look at sensors in garage 6 maybe find an option for a power point in wardrobe

Take down old light fitting and replace with new one and program it accordingly

Replace Existing Downlights. Looking for a qualified/licensed electrician to remove & replace existing downlights in our home. Replace existing downlights with new fittings x 10 (pls supply). 8 x Kitchen & 2 x Bathroom. If required the roof accessible through attic ladder. Thanks!

The tumble dryer turns on and sounds normal but the drum is not rotating.

Bathroom 2 x heater globe replace Hall 2 x globe replace 12’ ceiling Outdoor 1 x censor globe replace 14’

Power outlet needs to be refined to wall. See picture. Also fan/light currently operates on one switch, needs to be split out to two to operate independently.

Put in 4 double power points

Looking for a practical handyman to install a lightweight side gate between two units in Hughesdale. The setup: -Gate and frame are already purchased and on site - One side has an existing panel/post to attach to - The other side needs a support — looking at a no-dig/concrete-free post from Bunnings (e.g. ground spike anchor) Measurements: Total fence to path width: 133cm Gate width: 78cm Side panel: 31cm Path width: 84cm Gate height: 120cm Back panel height: 124.5cm Front panel height: 124.5cm (approx.) What we need: Someone to assess, source a suitable ground spike or stake from Bunnings (nearby), and install the gate so it opens and closes securely. No concreting, no panels, no major earthworks. Goal: Keep a dog contained. Function over form — doesn’t need to look perfect. Budget is $200 all-inclusive (your time + any hardware). Happy to discuss if you have a smart, cost-effective approach. This is a job for a confident handyman, not a fencing contractor. If you’ve hung a gate before, this is right up your alley.

Hi, I’m looking for someone to install some lights in my bedroom. It comes with a remote so i would need that to work and to be connected to the switch as well. You will need to come with your own tools since I don’t have any. The last photo is the current light I have.

Hi, I recently had a new bathroom window exhaust fan installed (Maxair 190mm Window Exhaust Fan). The old exhaust fan has been removed from the window but is still hardwired. I’m looking for a licensed electrician to safely disconnect the existing wiring and connect it to the new fan.

I need 4 light switches to be fixed as they are a bit flaky. It doesn’t switch on immediately and requires some fiddling around with the switch.

Looking for an electrician who can meet at my property around 5 one afternoon this week to disconnect a push switch and terminate it and disconnect a light fitting, and the reconnect after I have fed it through a new piece of weatherboard.

Looking to swap out my old NC-6 controller for newer one, house has 2 zones ducted gas. Will attach photos for reference.

Electrician required for the following: Inspect and repair two extraction fans (bathroom and kitchen – currently not working) Supply and install two double power points (one in lounge, one in bedroom – brick/concrete walls) Looking for someone experienced who can assess and complete the work efficiently. Happy to cover cost of parts and discuss any additional work required. Flexible with timing. Photos of fans attached. Licensed electrician preferred. Budget: $450

Need one wall light and one pendant removed and any live wires sorted so we can pull down fitting room walls safely.