Find a reliable appliance technician in Northcote

Repair smeg toaster. Hardly used

Looking for a plumber to come and check out our Asko dishwasher reporting an f11 outlet fault, we have checked the filter and tried a few things.

My washing machine is leaking from the bottom, me and my friend had a look at it but couldn’t find where the leaking coming from

Conduct a gas and compliance check and issue certificate of compliance for a double storey terrace

The machine is a breville barista express. we do have one seal left that i had purchased in the past online. i have tried to repair a few times previously but the seal is never quite right

Bosch Washing Machine – Drainage / Leak Issue Looking for someone experienced with washing machines/plumbing to diagnose and fix an issue with my Bosch front-loading washing machine. The machine is displaying an E36/-10 error and has been having trouble draining properly. There has also been some water and suds remaining in the drum. I've now noticed water leaking underneath the sink around the area where the washing-machine drainage hose connects to the waste plumbing. I've attached photos showing the under-sink plumbing and hose setup. Looking for someone who can identify the cause and fix the issue, ideally in the same visit. It's not a problem with the washing machine it's with the connection. Location: Northcote, VIC Appliance: Bosch front-loading washing machine Error: E36/-10

The dishwasher is flashing. Can you fix it

Clean and calibrate our Breville barista express coffee machine. We want a smooth clean shot of coffee.

dishwasher is leaking and unusable because of amount of water that it lets out. some kind of cleaning chemical was used prior to leak, so we suspected a pipe issue but cannot find the source of leak. westinghouse model and relatively new, we need to get it fixed asap.

Blocked washing machine, suspect likely due to kinked hose which might need replacing

Just moving into our new place and need our washing machine and dryer installed. They’re already in place but the inlet hose for the washing machine is not long enough. I purchased a longer one from Bunnings but , after attaching it leaked everywhere so thought I’d call in a professional to get it sorted. I’m sure a quick job for someone with the know how. Needs to be done between 8 and 9am tomorrow. Or this evening if available!

No light turns on when power is engaged, I have tried multiple gobes.

We ordered a washing machine and it is not fitting due to the particle board above it drooping by approx 1-2 mm. The washer can be pushed in about 70% of the way and all no issues on right side in so we know it’s extremely close. We need particle board shaved or cut with a planer or a chizzle or similar.

I have a Smeg oven model SA20XMFR8. Door seal, globes and LEDs on panel need replacing

Miele f24 error code. Dishwasher

As per picture there is an error message with the waahing machine. Nothing happens. With the dishwasher the latch for the dishwashing tablet is broken. You cant lock it.

Rebooking task between Tim and Michael

Hello, our washing machine is blocked and the door won’t open. We need someone to take the washing machine outside and open the plug hole, let the water drain and then put the washing machine back inside the house again.

I have an outdoor BBQ which used natural gas. I want it disconnected from the galvanised "T" connector which is located on the side of the house. We have landscapers re-doing the garden and want to remove the old BBQ, but need it disconnected first. The copper pipe (to the right) needs disconnecting (see picture)

I’m looking for someone to clean and restore a set of hand tools and a toolbox that have been exposed to rain and some liquid spills. The tools have developed surface rust and general grime, and the toolbox itself needs a thorough clean inside and out. I’m hoping to have the rust removed, tools cleaned up, and ideally treated or protected to help prevent further corrosion. This would likely suit someone with experience in: Tool restoration Rust removal Metal cleaning or detailing The tools are mainly standard hand tools (e.g. screwdrivers and plyers), not large machinery. Happy to either: Drop off locally (inner northern suburbs), or Have the work done at my place if mobile Thanks!