Find a trusted local electrician in Whitechapel

I have a single bulb USA floor lamp that needs rewiring. I have a UK rewiring kit.

I’m looking for an experienced handyman/electrician for two small but specific jobs. I’d prefer someone who is confident with both cabinetry adjustments and minor electrical work. Job 1 – Integrated Fridge Door Fix I have an integrated fridge built into a cupboard unit. The cupboard door that’s mounted onto the fridge has come off and needs to be properly reattached and aligned. The hinges and fixings may need checking or replacing to ensure it’s secure and sits flush again. I can provide photos in advance. Job 2 – Built-in Spotlights (Electrical) I have recessed ceiling spotlights (wired-in units, not simple twist-and-remove bulbs): Kitchen: One unit has failed completely and needs full replacement (not just a bulb swap). Bedroom: One spotlight is flickering and likely needs diagnosis (possible driver/connection issue or replacement). Additional notes: Please bring appropriate tools and any common replacement parts (or advise in advance if specific parts are needed). Looking for someone who can properly diagnose rather than trial-and-error fixes. Please only respond if you have experience with integrated appliances and fixed lighting systems. Let me know your availability and estimated cost.

Remove old electric water heater, install new(relocated)

Job: Change Roller Shutter Control from Key Fob to Keypad (Code Entry) I have an electric roller shutter that currently opens and closes using a remote key fob. I would like to change the system so that the shutter can be opened and closed using a wall-mounted keypad with a code instead of the remote. Requirements: • Remove or bypass the current remote control receiver • Install a secure keypad entry system • Keypad should allow opening and closing the shutter using a PIN code • The keypad should be mounted outside near the shutter • System must work with the existing electric shutter motor • Weatherproof keypad preferred for outdoor use Location: 18 Hessel Street, E1 2LP Please confirm: • If the current shutter motor is compatible • Total cost including parts and installation • How long the installation will take

I’m looking for a qualified electrician to come to our office to inspect and tidy up some electrical cabling. We currently have extension leads running across the office for the TV and other equipment, and we would like proper cable management done to make everything look neat, tidy, and safe. It may require securing cables, trunking, or possibly installing additional sockets (please advise after inspection). I am arranging this work on behalf of the office owner, who is currently on holiday, so I am looking for the most /affordable quote possible. Could you please let me know:

electric gibus awning / line not moving. need to programme a new Somfy Smoove and make sure everything connected to power it so it can move in and out again. This job is to site visit, to supply and programme a new somfy smoove. Any further work to be agreed and charged on top

Site visit to review our electric awning

Bought a microwave that needs to be plugged into a normal socket. I would like an electrician to do this.

The power has gone out in a section of our office, I believe due to plug overload.

fix a retractable electric gibbus awning

electric gibus awning not moving. need to programme a new Somfy Smoove and make sure everything connected to power it so it can move in and out

We have a wall mounted Mira Sport electric shower linked to heater system (heatrae Sadia Hotflo 10) which doesn't adjust cold/hot water properly (being either too cold or too hot) and needs re-adjusting

Looking for an electrician to change some bulbs in the living room, and 2 bedrooms. Need to replace the modern lights with the ordinary bulbs.

I need the appliances PAT tested for the rental, the electric connection to the boiler checked, and two sockets fixed.

Install 2 electric heaters into enclosed socket - wire them in.

Need a qualified electrician to install x1 lightbox (700mm width × 500mm height) at our store on Spitalfields - Mounting the lightboxes securely - Connecting them safely to the power supply - Ensuring all installations are level, secure, and meet safety standards Requirements: Relevant electrical qualifications and certifications Experience with lightbox or signage installation preferred Attention to detail and safety-conscious

Hi there, Can you please assist with the below issue? Issue: The motorised blinds in our living room are stuck all the way down and now won't come back up. When we pressed the "down button" the blind caught on a chair and it kept rolling. The blinds have now rolled down onto the floor further than their original setting.When we pressed the "up" button, the motor won't pull them back upwards. We tried this a few times, and the motor at the top "popped" with a loud bang and a flash. We're unsure if this was a fuse issue or not. I’ve attached some photos of the blinds. We unfortunately don't have the make. I have attached all relevant photos. Address: 62 Balmoral House, London, SE12QR. Many thanks,

My HVAC is stuck on, as is my electrical.hot water. I believe both are due to switches being broken. I also need a standard light pendant changing as an existing one is cracked.

Mains wired smoke alarm beeping. Needs to be replaced. Immersion heater cap missing. Needs to be fitted. Labour only price.

I would like to move my light switches to the other side of the wall that they currently exist on.