Find experienced local roofers in Inner West Sydney

couple of roof tiles have been moved due to the wind. Water is leaking through the hole. Double story building

Please state quote and timing to do the job - Flashing gable end where the leak is coming through.e.g where the water buckets are in place in theupstairs attic - Remove the terracotta tiles in the valley, starting from the bottom of the valley on both sides all the way up until the ridge 4.5 Lm to gain access to the rusted out valley. Remove the top 3 ridge caps to be able to remove the valley- Remove the old lead at the valley,then remove the old rusted out Zinculume valley - Remove the gable end tiles,then remove the old cement. Clean the entire area, then remove the old 2.6Lm fibro cement - Install new lead 20 kg Lead(350 mm) to the bottom of the Zinculume Valley, also paint the lead to stop oxidation with it and the Zinculume Valley - Install a new Zinculume 4.5 Lm valley, re-lay the existing terracotta valley tiles and make watertight - Re-bed and point using 1025 colour (Flexi-point)to the ridge area where the existing ridge caps were removed - Install a new fibro/z- flashing to the gable end area as you look out of lefthand side window area as discussed.Re-bed & Point this area and make watertight - Cut 10 mm off the bottom of the gable end fascia near the bottom of the valley, - Replace 3 roof tiles or any more we notice while working over the roof area (Owner to supply roof tiles) - Remove old pipe, and install new PVC pipe to channel rainwater down to the gutter - Clean and Reseal 3 aerial cable points of connection with sealant - Full clean up of works on completion of the job

Need to pressure wash roof and repoint ridge cap and seal chimney , roof is not too big approx 16m x 4m wide it’s half house as two houses seperated but same roof are joined only need to do one side, neighbours no need. A

Garage gutters cleaned. Enquiry about gutter guard and the cost.

I need old polycarbonate sheets replaced with flashing to waterproof on small tool shed - 1.6m x 2.3m area. I have necessary materials including new polycarbonate sheets, dome washer roof screws, and lead and Byute flashing. Roof is approx 2.7m high, with access available from neighbours roof as well as inside our property. New sheets will need to be cut to size (approx 4 sheets will be needed) , and flashing applied at edges to properly waterproof.

We have a roof with solar panels and I need to take 2-4 panels off for 2-3 hours to fix the roof below Roof is quite flat, can store panels on site, and on roof. Photos to come later

Hi there, we need someone experienced in roofing to have a look at the back awning of our property as there’s water coming into our kitchen when it rains and also around the back door so I suspect either blocked gutters or a small leak. This happened if few years ago and we had the roof patched. May need to touch up.

I have 2 low profile roof ventilators to install on my colorbond roof, new instal. Looking to arrange a quote.

We have a downpipe that goes u der the deck and out onto the grass, we need to redirect the pipe to go to the other side of the deck instead. Change where it turns left to go straight ahead instead.

⸻ My Mercedes Coupe 207 (2010) has a problem the sliding sunroof net at the top is damaged. If anyone can offer me a cheaper quote to fix it, please let me know.

Clean gutters and metal roof with water blasting

Clean out clogged gutters and built up soil on the roof and remove garden debris down the side of the house

I've just moved into a ground floor apartment and I've noticed that when noise comes through from the foyer, it’s quite loud. The door has fairly large gaps around the edges, so I was wondering if there's a way to soundproof it. I've attached some photos of the door-please let me know if anything can be done. Thanks!

Clean gutters. Send photos of after clean via text. Bring sealant just in case you to repair any gaps I’ll pay you $100 extra to seal gaps with photo evidence. Give me quote on gutter guards via text. I will be busy working and only want to communicate via text.

Provide an estimate for fixing roof leaks. It is at the rear of the house with a tin roof and fibro construction. I think the leaks may be able to be patched rather than a full reroofing.

13m of gutter guard to be installed I have all materials on site 2 storey / good access Needs to be done from ladder Also need a hand with installing a down pipe and nossel (straight run to the drain) Would be great to get this done today while the rain has stopped

Install rainwater downpipe from 1st floor roof gutter and connect to rainwater pipe below ground. Estimated hight of downpipe is 7mts. The existing downpipes are aluminium rectangular downpipes 100mm x 5m.

We have a semi but both side would like their gutter clean. Single story. Your can google the house 86 Moonbie st

Looking for a quote on a job to clean away all dust from the ceiling. Removing all legacy insulation.

Looking for a skilled tradie to replace guttering and fascia on one side of my building. The area is approx. 5 linear meters and has easy access. Scope of work: • Remove existing gutter (approx. 2m) • Remove and dispose of rotten fascia • Supply and install new timber fascia, painted in Colorbond Monument (approx. 5m) • Supply and install slotted high front quad gutter in Colorbond Monument (approx. 5m) • Supply and install 90mm round PVC pipe to run water to front awning and turn into spreader • Remove and dispose of all waste/trade materials Please bring all necessary tools and materials. Budget is around $1,000, but open to reasonable offers based on experience and quality of work. Let me know your availability, experience with similar jobs, and any questions you have.