Find a professional internal door contractor in NSW

Looking for someone to pick up (Bunnings Ashfield 5min up the road.) an internal door, hinges and handles and install at my ground floor apartment in Hurlstone Park. Door frame measures 790x2020 and has no exisiting hinges or strike plate installed. Let me know if you have questions 🌞

Looking for a suitably qualified person to fit a single cylinder deadbolt to the door between our garage and office. Deadbolt has already been purchased. Must have suitable tools and experience. Let me know your quote and when you'd be able to attend.

Door frames are metal so hinges can't be removed. Therefore pins in hinges will need to be "popped"

An internal door between a living room and store room

Two internal doors need replacing due to cracks. We are in a rental. Silver bottoms off blinds need to be put back on. Not sure what to charge. Happy to chat further.

Trim doors to allow for new carpet

3 internal doors needed to be hung. More work for the right person

Insured and experienced carpenter to remove and plane internal doors, approximately 13, as well as dab some undercoat on each before refitting. Hinges are clean of paint so no complications expected. Doing to enhance air conditioning flow.

Re-align internal door. After renovation internal door needs to be aligned by a few mm so closes properly.

Bathroom door currently sits flush with floor, I need a couple of centimeters cut off the bottom to allow drainage hose to pass under door. Refer attached photo, bathroom door on right hand side.

Materials supplied just install door + jamb + handle

I need a bathroom door replaced and installed, I have the blank door from Bunnings already, just needs to be fit and put up. It’s a standard door and standard size

Internal door needs replacing. Door and handle supplied. Old door available for size reference. No painting required.

Internal door installation. Frame already installed. Blank door (supplied by me) and internal lever handle (also supplied) needs to be installed Door frame is approx W 74cm H 196cm depth 5cm

I have 5 new internal solid doors that need hanging / installing. All materials supplied including doors, hinges and handles. New doors are solid but light weight and require cutting to size.

I have 4 x old internal doors which need to be removed and 4 x new internal doors installed in their place. Out of the 4 x new doors, 2 are the exact size of the door frames while the balance 2 x doors need to be cut down to fit. No painting required.

Remove and install 5 interior doors, hardware provided need to install handles into door, including cutting holes to fit. Remove and install bifold door hardware required. Will reimburse for hardware. Remove old doors.

Looking for an experienced chippy/handyman to replace 8 internal doors (hollow core) Doors are supplied Hardware is supplied Painting not required Doors will need to be trimmed to length - handles + hinges installed (non-mortise hinges) I will dispose of old doors.

I need about 50 mm shaved off the bottom of a wooden door and then have it re-hung. I need this job done urgently within the next two hours.

Four existing doors need planing to open/close easily. plus I need a new door hung.