Find a professional laundry tub contractor in NSW

Need to replace the laundry tub and remove the hot water tap for washing machine.

• Replace the kitchen tap with a like-for-like tap set. • Replace the laundry taps with like-for-like taps. • Install and plumb in a new laundry tub. All labour cost only.

Remove laundry tub and plumb washing machine into pipe. Take dryer off wall and install side by side

Remove a Laundry Tub. Ensure existing Drainage will still take water from Condensor Dryer. Tidy and fit off drainage as required. Tap is wall mounted and will be retained for future use. Move washing machine and dryer into where laundry tub was (currently sitting next to Laundry Tub, stacked setup) Estimated time less than one hour for experienced plumber/handyman.

Looking for an experienced handyman or plumber to: *assemble completed but needs to have tub and sink hole cut out. * Dispose of existing laundry tub * Install securely into laundry area * Connect existing plumbing and waste pipes * Ensure neat alignment and professional finish * Apply waterproof silicone sealing around edges and joins * Leave area clean and tidy after completion Important: * Experience with IKEA assembly and laundry installations preferred * Must bring own tools * Please advise if any additional plumbing parts are required * Looking for a high-quality, neat finish with attention to detail

Hi there, I’m looking for a certified plumber to remove and install a new 600mm laundry tub, as well as remove and install a new full toilet suite. The property is located in Campsie. I will supply the new laundry tub and toilet, however you will need to supply and install the trap and any required fittings. Please see the attached photos for the job. Thanks.

Need a licensed plumber to: 1. Disconnect and remove existing laundry tub 2. Cap water and waste pipes (temporary) Will require a second visit later to connect new laundry sink after cabinetry and bench top is completed. *** Must be licensed and insured (strata requirement)*** Location: Schofields

Flat pack shower stall install in place of laundry tub.

Need the fittings under laundry tub changed as they are dripping when no hose is connected. Also the mixer tap is not letting much water out. Not sure if everything needs replacing or fixing

I need to install in Bathroom: 900 vanity Mirror Towel ring Toilet holder Towel rail Install in laundry 500 laundry tub Toilet holder Towel rail X 2 Remove existing fittings and dispose. Install new fittings which will be provided. Fittings need to be collected from Ostar In Revesby.

Dishwasher and laundry tub installation plus removal of old ones

Looking for a licensed plumber to complete the following job: Disconnect existing plumbing Remove current laundry sink/tub and place it in the garage for later removal Supply and install a new 45-litre Everhard laundry tub Connect new plumbing Secure tub properly (glued/siliconed and fixed in place) Ensure all plumbing is fully connected and working correctly, no leaks Finish so it looks clean and professional. Please see current plumbing on image as its a copper pipe going out the side of this so may need a hole cut in the side :) Requirements: Must be a licensed plumber Must be available Wednesday at 11:30am 21st Jan) Please bring all necessary tools. Thank you.

Supply and install laundry sink with mixer tap with combined washing machine drainage. Sealed connections are available. See photos

Remove old laundry tub and cabinet (1st picture) Install new one, reuse old tap and connect everything New tub will be provided (2nd picture) Anytime on 17/1 or 18/1

Disconnect laundry tub and return after 7th January to reconnect tub

There is a cavity behind the Laundry tub due to water burst in the pipe lines, to fix with Gyproc or cement sheet and fix the laundry tub back in place.

Looking for a plumber who can install/connect an existing laundry tub (would require cutting base of tub to allow pipe to fit) pictured, replacing the old laundry taps and spout with the ones pictured, and uninstalling/removal of the bathroom vanity (don’t need to take it away). Please see photos.

Details: I need a plumber/handyman to: • Disconnect and remove 1 x toilet and hand spray (see photos) • Cap off water and waste connections properly • Disconnect and remove laundry sink, tap and trap under cabinet (see photo) • Cap off connections so they are safe and sealed • No disposal required – all items are to be safely removed as they are to be re used Requirements: • Must bring own tools • Must ensure water is shut off and capped securely • Licensed plumber preferred but not essential if you are experienced with plumbing disconnections Photos attached for reference.

To install a new tap in laundry tub. Two options for inlet connection. First is existing Tap( meant for Washing machine) and the second is Toilet inlet valve. I believe splitter will be required is any option.

Install laundry tub and mixer