Find an experienced door installer in NSW

Install an aqara smart lock and fix doors that aren’t properly closing

Need a bed room door installed door , everything here including new door and handle

Looking to have my door lock replaced with this one

(1) shave/sand new front door to size of front door entrance (2) install lock system in new front door (currently no hole in door for lock so the hole will need to be appropriately drilled and sized in the door) (3) size and drill hinges to new front door (4) remove existing front door from front entrance (5)install front door in front entrance (-) Door, lock and hinges supplied. (-) Can be available to assist. (-) Here is a link to the door which has tripled glazed glass (so is heavy) https://heritagebuilding.com.au/products/solid-exterior-cricket-bat-and-heavy-moulding-glass-panel-door

The oven does not close adequately - lets too much heat out when in use - new hinges were purchased and installed - although not correctly - as a result we would like this looked at again - not having co fidence in the earlier person who worked on it

Need a handyman for the following tasks: 1. Install Gainsborough Smart Deadlock on main door 2. Instal bedroom door handle Ikonic brand 3. Secure book shelf to wall. It’s on carpet and shaky at the moment. 4. Fix dryer on wall (bracket and screws available) 5. Sliding bathroom door not gliding smoothly.

Hey, need someone to either replace this door or get it fixed please Thankyou

Only labor to install front entrance door for a small house, standard size

I need someone to install a new door on an existing frame. I already have the door, hinges and lock from the previous door.

Only bathroom door handle needs to be removed. I have bought a standard door handle to replace it with.

My bathroom has a concertina door and I want to replace with a hinged door. There are hinges and door strike on the door frame from before. I also have a solid wooden door that can be used which has hinges and door lock already installed. However this door needs to be cut and reduced by 1 inch roughly to fit. Open to a carpenter getting a hollow core door if thats easier. Located in Ambarvale, NSW

I have two door handles, one is the front door handle, it's loose and I think just needs tightening up but I have no ideas how to do that. The second is an internal door handle for our main bathroom. The nib lock is broken and it's also coming very loose, I think this one will need replacing (please note, I don't have a replacement so this quote would include the cost of a new handle please, matching as closely as possible the one in the pictures).

Doggy door installation- we have purchased the doggy door, just need someone to please assist with installing this into our wooden door.

Install door closer and new door lock. Pictures attached.

Install door excluders to stop dust and leaves blowing inside.

Two doors - see below First job I need a door frame and door built in my corridor - see photo (looks like a standard sized opening) If you can also put gyprock and cornice above the door to close off the space. (I have left over gyrock and cornice) Second Job I need a door only installed to my bathroom. It was previously a small folding door approximately 70cm wide. I just want a normal swinging

Bought a door 820 x 2040mm and it needs to be cut down slightly and then installed. I have the hinges already in the frame and hardware for the door to be installed. Strike also needs to be installed.

Doors and shelves need to be installed. Everything else is done Instructions for doors- https://www.ikea.com/ph/en/assembly_instructions/pax-pair-of-sliding-door-frames-rail-white__AA-2213695-8-100.pdf I have taken a photo of drawers and shelves

Need glass replacement for a sliding door. Dimensions: 223cm x 100cm

Hi, I need to have a lock/key combination to be installed for small door for a room - underneath the door handle - please see the attached pictures for detail. Thanks, Dan