Find a local timber flooring profesional near you

Hallway carpet needs to be ripped up and timber laid as dogs have ruined it during the colder/wet months. Area is approx 15m2. Timber and tools would need to be provided as nothing at house.

We several dark water stains on our timber floorboards which need to be repaired as part of an end of lease clean. The stains were caused by water collecting below pot plants and a long mirror. In the first instance, we are hopeful, some stains can be repaired without requiring sanding and refinishing. Looking for a professional floor expert to help us with this job.

Replace carpet with engineered timber - 5 bedrooms, stairs and 1 small living room. Supply & labour

Need someone to replace 5 small damaged timber floor boards (30–40 cm each). Boards need to match existing size and type . No staining or finishing required, just replacement. Looking for someone experienced with timber flooring repairs.

House, ground floor, front room. Timber, raw, spotted gum, 80mm W, T&G. Full installation including: moisture barrier, direct stick to concrete (glue & nail), sanding and polishing.

New Tallow wood front deck to be sanded and oiled. Existing rear deck to be sanded and oiled.. They will be pre washed ready for Tradesperson to sand and apply natural oil.. Oil will be provided.

Remove both treated pine and merbau

Need 2 timber decks sanded and oiled. Size is around 15m2 and timber is spotted gum.

Need someone to finish this timber flooring in the areas in the photos(including under fridge). Some panels may need to be removed (eg. Where cut on an angle) to allow for a clean finish. I have the flooring panels onsite. The floor that is concrete in photos needs to be levelled with the tiled areas. I have some 9mm boards made from MDF to cater for this. They need to be cut down and fitted before the timber flooring is placed down.

Experienced Handy person needed to install floor boards Approx 2.5m2 Engineered floor boards - glued down to concrete Please apply if you have experience Must bring own cutting tools. etc Floor boards and glue included - Install on Monday May 11 - preferable morning

Protective floor pad moved from couch leg and adhesive from this stuck to the ground. When I went to lift couch to move it, it ripped this piece off in one clean chunk. The irony.

Timber deck approx 5m x 4m All boards and framework to be pulled apart, removed and taken away

I have a pine timber deck about 3m x 3.2m which needs sanding back so that I can stain it. I tried to Gerni off mould and now it’s patchy ☹️

Looking for someone experienced with timber floor repairs to fix a few small chips/gouges in our wooden floorboards. Damage includes: -A couple of small holes/chips in the wood -some surface wear/scratches in nearby area I’m not looking for a full sand/polish at this stage — just a tidy cosmetic repair (fill, colour match, and seal if needed) to make the damage less noticeable. Please bring your own tools/materials and have experience with timber floor patch repairs. Photos attached.

Timber floor is sagging & needs either propping via a new stump or potentially filling with concrete -

Timber decking requiring surface preparation and staining or oiling. Approximately 32 m².

I have a timber fence that has been pressure washer cleaned in preparation for oiling/ staining. I need the fence sanded lightly to remove some of the furry timber that is a result of the pressure washing. I have sanding equipment on-site to use if required.

Timber lining panel installation required 3 x walls 2.8 x 2.8 meter approx 1 x wall 2.8 x 6 meter approx I can supply timber panels you will cut to measure and install in Granville

sand and polish an existing timber floor in a two bedroom unit

I’m converting a small storage room into a study nook and need floorboards installed to cover an exposed concrete subfloor where built-in cabinets were recently removed. The job involves three tasks: 1. Lay Floorboards ∙ Install supplied (matching) floating floorboards to match the existing light timber flooring in the adjoining area ∙ Boards need to butt up neatly to the existing flooring at the threshold ∙ The subfloor is bare concrete with some old adhesive residue from removed cabinetry – light prep/levelling will be needed before laying ∙ Please bring underlay – I don’t have any on hand 2. Install Skirting Boards ∙ Install supplied skirting boards around the perimeter of the are as shown in the photos to finish the floor edges clean 3. Patch Holes in the Wall ∙ There are a few holes and damage spots in the walls left over from the cabinet removal ∙ Please patch and prep the walls ready for painting – I will do the painting myself, so just needs to be sanded smooth and ready to go. I will supply the filler for the wall patching. This is a relatively small task for someone that knows what they are doing.