Find a local timber flooring profesional in WA

I have a small outdoor space in front. Plan to do some devking to uplift it. Please quote for a low-level floating courtyard deck over the existing paved/concrete area, not attached structurally to the house, with no roof, no balustrade, no privacy screen, and a raised garden border kept under 500mm. Please ensure drainage access is maintained

Timber floors need rejuvenation. One area needs minor repairs

After someone to sand back timber decking to bare wood and oil with natural oil. 50sqm of Decking (Merbau) Also need 5 2m lengths replaced as showing in last photo.

Repair/adjust loose merbau decking boards, front and back of house. * There are half a dozen boards that need reaffixing (nails not screws), some of these need to be realigned too (maybe using some sort of spacer to hold them in position). * There is one section of 3-4 boards that has a slight spring to it, I suspect the joist needs fixing. * While you're here, I'll also ask you to punch back in any other nails which have risen over the years (maybe 20- 30 nails in total). Happy to consider an hourly rate or a fixed amount.

Hi there, I need a handy person or a flooring specialist to repair a damaged section on my timber flooring. The Issue: There is an area with a cluster of heavy dents/scratches (as shown in the photos). The top protective coating in that specific spots have cracked and flaked off slightly due to the impact. The damaged area is relatively small (approx. less than 15cm x 15cm), located on 1 or 2 floorboards. What needs to be done: 1. Clean/lightly sand the loose, cracked coating around the edge of the dent so it doesn’t peel further. 2. Fill the dents to make the surface flush/level with the rest of the floor. (Hard wax melt repair or timber filler method preferred). 3. Touch up with a clear seal/coat (Satin/Gloss) over the repaired spot so it blends in and is protected from moisture. Requirements: Please bring your own tools and materials (matching fillers/wax and touch-up coatings). am not expecting a 100% invisible factory finish, but it needs to be level, sealed, and visually blended in as much as possible so it’s not an eyesore. Please send through your offers and let me know what method/materials you plan to use. Thanks

Quote me for one room to remove old timber floor

Looking for a qualified and experienced carpenter/deck builder to ideally repair and rejuvenate our front covered wooden deck at our home in Innaloo. The deck is approximately 6.7m x 3.2m and is worn/weathered in some areas. We’re open to recommendations and pricing options, to replace only the worst affected boards/panels and restore/re-varnish. We would also like the existing L-shaped wooden seating removed, with ideally one section rebuilt/reinstalled along the house wall. The current seating frame may be reusable and the storage space underneath is currently used for a mower and gardening tools, so would like to retain some storage functionality if possible. Open to quotes and advice from experienced carpenters. Please only apply if you have relevant experience and examples/photos of previous work. Thanks

House, ground floor, front room. Timber, raw, spotted gum, 80mm W, T&G. Full installation including: moisture barrier, direct stick to concrete (glue & nail), sanding and polishing.

Minor Restoration on timber decking. Sand, replacement nails & stain size 40sqm.

Scope of works: Install timber floorboards (area <5m) Spare boards supplied Concrete floor already prepared (see photos) Install skirting boards (length <3m) Materials supplied Patch, plaster and paint small linen cupboard wall (area <5m²) Finish in white paint Paint skirting boards (<3m) Notes: All materials supplied (timber boards + skirting) Floor substrate is concrete and already prepped After a neat, professional finish (flush joints, clean edges)

Remove small timber deck and general clean up of front courtyard help with retic repairs

Approx 45 sqm of timber decking We are needing someone to clean and oil. Please only apply if qualified and know what you’re doing Photos of some of the decking attached

Whole floor sand and polish

I want install timber floor

Decking in the backyard needs to be done with replacing the old rotten wood floor with treated wood

We are looking for a quote to jet wash timber posts (50 mm × 50 mm × 2100 mm) that have some mould on the surface. There are approximately 4,500 pieces strapped on pallets. Each post is about 2 m long and will need to be cleaned using a jet pressure wash. Work details: • A licensed forklift driver will be required. • Pressure washes each timber post to remove mould (some posts have small areas of mould). • Re-paint the timber posts after drying, as required by the factory. • Bundle the posts in groups of 100 pieces and stack them in the storage area.

Looking for an experienced carpenter or renovation builder to quote on raising a timber floor in a character home in Bayswater WA. Details: • Timber frame house (no concrete slab) • Existing jarrah floorboards • One room needs to be raised approximately 50–150 mm to match the adjoining room level approx. 15m2 • Ideally would like the existing jarrah boards lifted and reused if possible • Subfloor access available Scope may include: • Lifting existing jarrah boards • Installing timber packing/subframe or new joists to raise height • Reinstalling jarrah boards Happy to discuss the best method recommended by the carpenter. Looking for someone experienced with older timber homes and timber flooring. Photos available if required.

Timer repairs outside deck

I need my timber floor leveled so we can install boards over the top. At the moment it has a significant raised area in the hallway. This area needs to be removed and replaced with plywood or chip wood so it is at least straight enough for installation of floorboards over the top.

Looking for someone who is suitably qualified to repair some flooring that has been damaged due to a leaking freezer. No spare flooring available so would need to be sourced. Please reach out if you can help