Find a local timber flooring profesional near you

Timber decks, hand rails and steps need to be chemical washed, sanded and resealed. 4 decks in total, 2 upper and 2 lower. Deck still in reasonable condition not very old, only light sand is required but will need to be washed prior due to some moss growth from a tree. Approx 140m2 of decking surface area.

Spot cleaning and Sanding of all floorboard surface area's in the kitchen, living room and staircase. Around 30 to 35 square meter in area. Minimum 2 coats of floorboard varnishing of kitchen, living and staircase if required. If not fixed with patching work.

Timber Decking Construction / Replacement Works QBCC Licensed Building Contractors are invited to quote on the following Decking Construction / Replacement works to an Existing 70’s residence in Mudgeeraba. 1.0 Front Entry Deck Demolish and replace front deck, structure, decking, handrails balustrades, stairway and steps to match existing. Replace all timber elements with size and material to match original existing (or better) 2.0 Back Balcony / Veranda Demolish and replace rear balcony / veranda, structure, decking and balustrades to match existing. Replace all timber elements with size and material to match original existing (or better) 3.0 Garage Eaves/ Roof Repair Demolish and repair rotted, Eaves, Facia, Gutter and Truss Elements to match existing

Oil from diffuser fell on the timber floor and has left a stain. Need it to be lifted as part of end of lease.

I need floor timber floor polished in x2 bedrooms and wardrobe Around 3.5m x 2m each room Wardrobe about 2.5m x 600mm x3

We have removed an old deck and have some decking paint built up on the pavers below. We need a person with a machine to do a very light grind. We have about 4 sq m

Small deck 1.3m x 1.2m Need to replace the timber boards

Replace a broken timber on my deck. Supply and install. No need to stain or lacquer. Timber is around 1.2m long

Repair damaged area of timber facia board on portico. Fill, sand smooth, prime/seal and repaint (paint supplied)

Rough sand of posts and 2 coats of Aqua deck which i have. Only sun facing posts are worse as in last image.

Floors are 4 years old. Some chips and scratches I'd like repaired/concealed where possible. I'd like a coating (probably polyurethane type?) that will better protect the floor and last a good while before needing recoating/refinishing again. Current finish appears to be fairly natural/matte or satin. I'd like to go for satin this time for a slightly better and modern look. Area (in metres) Living: 6 x 4 Laundry area: 1.5 x 1.5 Hallway: 4.9 x 1.1 Entry to bedroom 1 x 1.6 I would do it myself but want someone with experience in floor surfacing suck as this to provide the right guidance and excellent products with a professional finish. Photos of areas included. Also added photos of damage/chips scratches.

The handrail has already been mostly prepared. I just need someone with the right tools and attention to detail to carry out the final sanding so it's smooth and ready for staining or clear coating.

Repair these chips in the timber floor for a commercial office move out

Fixing floor scratches on floor

There is a small wonky bit on edge of our timber decking - circled in the photo below. When you step on it, it is bouncy. Looking for a handyman to help me fix this!

Assemble Asco Shed Timber Flooring Kit which comes with screws, not nails. All necessary hardware and fixings for the timber frame and floorboard installation are included in the flat pack kit. 1.58m wide and 0.78m deep.

Engineered timber flooring installation for 2x3 room. Room is new. The following will be supplied 1. Click lock floorboards 2. Underlay 3. Skirting No painting needed.

Raised brick foundation house has gaps around the perimeter of the house allowing access underneath. Horizontal timber decking installed to cover any access (from dog) under. Approx 25meters