Find trusted local electricians in St Peters NSW

We just noticed that our inverter for our solar panels has fallen off the bracket of the wall at some point in time and was found to be not powered on the ground. We have switched off. Need someone to inspect whether any repairs are required and re-fix it to the wall, happy to pay $100 for someone to come out and inspect and quote for any further work that is required.

Power point on wall in my house, all of suddent doesnt have any electricity

Need a licensed electrician to replace my gas cooktop with a induction cooktop. Will require a dedicated powerswitch and line installed. Happy to discuss a suitable time that works.

I need a Wieland GST18 3-pole wall plate replaced with a GPO or a tail to convert the connector on the wall plate to a socket.

Need an electrician to add to two power sockets, to add a dimming feature to lights if possible

Our downlight near the pantry has stopped working. Need it replaced. Simple job.

Need aircon moved from ground to wall mount, approx 3m movement

Replace 2 electrical wall sockets

Device cools most the time but sometimes only pumps hot air. Wondering if it’s a pressure issue (maybe needs a recharge?) again it works produces cold air but sometimes reverts to hot air only. When I reboot it i can usually get it to pump cold air. No error codes or anything displayed. Parking available right out front you can come anytime of day.

I am providing all supplies quote labor only. Everything to be surface mounted. See photos. Registered sparky only and quote your license number. 1. Replace 4 existing 2 pole RCBOs with single pole RCBOs. 2. Install a 63A 4 pole 3phase RCBO and connect pre-run cable and connect it to hot water heater. Cable already run you just need to connect 3. Install subboard with 63A MCB, 2x 32A RCBO, 1 20A, and install two new outlets (2nd 32A already mounted 4. Install one further 20A RCBO to connect to a 20A outlet (also to be installed, surface mounted)

Two light switches require replacing

I need a power point - all power lines exist - just need the power point connected

There was a power outage in the area, and after power came back, some power outlets in the house stopped working. I checked the switchboard and noticed that when I turn on the breaker for the outlets, the RCD (residual current device) trips immediately. If I leave the outlets’ breaker off, the RCD stays on. I have already unplugged all devices from the outlets, but the issue persists. I need a licensed electrician to inspect and fix the issue — it could be a faulty outlet, water ingress, or wiring issue.

https://www.bunnings.com.au/deta-3000-double-power-point-with-usb-a-c_p0608947

Need someone to install this AC - Carrier Allure 5KW wall slip system We require: Back to back full install and electric cables to be run from the outdoor unit to the front of the house where the electrical switch board is located. Licensed trades only. - Due date: 04/12/2024

splice incoming nbn cable

We need to replace an existing bathroom vent fan as it’s old and making loud noise when it’s on;, you should be a licensed electrician. Will need to troubleshoot our existing fan to see if we can repair the existing exhaust fan motor, or replace the unit entirely.

I have two bathrooms, each with an exhaust fan. The exhaust fan is currently connected directly to a wall switch in each bathroom. I have two shelly relays and need them to be installed in each bathroom to control the exhaust fans. I will need a licensed electrician to complete the job.

Need someone to install this AC - Rinnai 5.2kW Split System Air Conditioner DRED Enabled HSNRT50B - Due date: Before Tuesday, 9 January 2024

The hardwired smoke alarm in our granny flat (located in hallway outside bathroom) often goes off when someone is having a shower either due to the bathroom heat lamp which is nearby, or steam (unsure of exact cause). It also sometimes momentarily goes off when someone even flicks the switch in the bathroom to turn the light on. Hoping if we replace it with a new smoke alarm that will fix the problem. Wanting installer to supply new hardwired smoke detector too. - Due date: Needs to be done on Wednesday, 27 September 2023