Find experienced local carpenters in Dee Why

Assemble a damaged motorised sit stand desk that get damaged during moving. The rivet holes & attached screws gave way. I replaced these holes with the pictured plugs from Bunnings and sanded them in place. I need someone to complete the job, as I'm worried if I do it, I'll damage the desk further.

Absco sace saver shed put togeter - Due date: Flexible

Demolish flimsy chicken coop. Made of various materials - wire, wood, plastic corrugated sheet. Triangular. Approximately 1.5m x4m narrowing to .8m

Replace the cornice (coving) around the top frame of a mirrored wardrobe. We want to bring the frame forward to make the robe deeper so new cornice is needed around the top frame. The new coving will need to be joined (mitred) in to the existing cornice. Total length is less than 2400mm. - Due date: Flexible

Hi there I need two custom pieces of wood/architrave to use for filler panels at the side of a cupboard. Preferably white. They are quite skinny and awkward sizes below: pc 1: 9mm D 27mm W 2414mm L pc 2: 9mm D 27mm W 2397mm L Open to both delivery and pickup options within 10km radius Open to quotes, please explain the services you’d be providing :) Any advice would be appreciated - Due date: Before Friday, 22 December 2023

Replace exterior door to storage area. Roughly 70cm width, 1.5m in height. Current door has rotten wood and falling apart, so need to take off all old wood and replace with new. We can dispose of any old material. Replace with sturdy door as used for storage. Should be lockable (just using padlock is fine) - Due date: Flexible

I'm installing a new kitchen with higher cabinets that go up to the ceiling. Currently, the switchboard is lower down and is currently in the way of storage space and will be in the way with the new kitchen. I'd like to get a quote on moving the switchboard from its current location to higher and left as shown in the images. - Due date: Flexible

We want to build a custom bookshelf with some cabinets in our entrance hallway. The bookshelves are built in hardwood in warm tones (or nice veneer) and supported on one side by a partition to be built, and on the other side by a wall. The bottom cabinet is built using white veneer. We would ideally purchase the material ourselves based on your recommendation, but would also accept quotes that include materials. You will find an estimation done by a builder of the amount of wood / veneer needed below. It does not include the cabinet. Top shelves (3 shelves): 3 x 2.4 m = 7.2 m Counter (2 side-by-side boards): 2 x 3 m = 6 m Partition (to support the bookshelves on the left): 1 x 2.7 m Small shelves on the left: 3 x 0.6 m = 1.8 m Cabinet length: 2.4m You're also welcome to visit to quote. Looking forward to meeting you, - Due date: Before Saturday, 25 November 2023

I have a bar area measuring 2600x2400x800 that requires enclosing within a Gyprock wall. It may need a small frame to enclose and will require a skirting board added at the bottom. Materials to be supplied as part of the quote. - Due date: Before Thursday, 30 November 2023

New sofa - 261 x 93 x 80cm Located in garage on-site Approx 40kg. (See photo) 1st Floor Balcony height from ground 6m (see photo – the middle balcony) Easy access below (see photos) Protection needed for balcony glass panels and railing (photo) Insurance required - Due date: Needs to be done on Thursday, 19 October 2023

Have a small garden shed that’s been delivered in 3 boxes. Looking for someone to construct it. This is it: https://www.catch.com.au/product/giantz-garden-shed-2-38x1-31m-outdoor-storage-sheds-workshop-cabin-metal-house-2143097 - Due date: Flexible

Hello! I’d love help from a carpenter or creative woodworker hobbyist looking for a project to build a fun catio for my balcony. Approx. 1.4 x 1.4m and 2m high and to be attached by one side to the wall as you see fit. I’ve attached some images of the overall vision, but I essentially need the basic wooden frame with a door, the wire mesh, and some multi level platforms attached to the inside. (I’m also open to any creative suggestions like bridges, home made cat towers etc if you want to quote them too!) It’ll also require a short ground level tunnel to the cat flap and outdoor wood treatment to cope with the elements! Open to quotes and offers at this stage (please ignore my $ budget, I want to pay fairly for a good job). Will ideally benefit someone who can come check out the space and get accurate measurements as we’ll need to work around an air con unit too! Apartment is in Dee Why. - Due date: Before Sunday, 27 August 2023

I have a few jobs in the house to complete which I need some help with, looking for a chippie with good tools to complete. The jobs are as follows - 1. Install Skirting 7m approx various 2. Half dowel around new kitchen Island 880h x 3500w 3. Fc Vj wall on external deck 1470h x 2600w I can supply all the materials ready on site to cut and install. I'm hoping all of this can be done in 1 day. Thanks - Due date: Before Saturday, 29 July 2023

We have two areas of decking with wood rot that need replacement. One is small under a cabana and another behind our pool. We are happy to stain and treat the timber but open to a quote for this as well. In Cromer - Due date: Flexible

I'm moving out and leaving behind some gnarly oil stains in my car spot. Perils of an old car. I need the stains to be cleaned as far as possible by someone who knows what they're doing and knows the best plan of attack. - Due date: Needs to be done on Wednesday, 12 April 2023

1. A hole in the wall upstairs requires fixing 2. We require a cornice to be built around the top of an existing fireplace - Due date: Flexible

Looking for quotes to convert a small garden (approx. 3x8m) into a deck (approx. 2x6m) Garden photos are current Deck photos are to show we we're looking for - Due date: Flexible

Hi as discussed need to make cabinet

Accidentally bleached my carpet with cleaning products. Can this be fixed, repaired ? - Due date: Flexible

We need some shelving built and installed for the reception area of our salon. We would love to have small boxes shelves that are floating, but open to ideas of what you think would work. I was thinking maybe 6 boxes, different sizes. They don't need to be bigger than say 400mm(h) x 400mm(l) x 100mm(d) Looking for the same look as the timber frame you can see on the right. I'm not sure how much this would cost so my price is an estimate only. - Due date: Flexible