Hire an affordable Carpenter for any job Near You

Bike shed Slimline F36 1.07m x 2.1m Sgl Door-Slate Grey

Hi, I would like to build some wardrobes for my home with rolling glass doors. I have attached the measurements and the style i'm after. It's for bedroom, corridor, garage and a pantry style in kitchen. I would like to have the costing quote split individually.

Need help with a garden steel shed assembling. product comes with anchor set/Skylight sheet/ramp; Shed size: 2.25 m (W) x 0.78m (D) x 1.95m (H); Concrete foundation was laid.

Grafico vinyl base wallpaper installed on the backing of a storage/mud room unit. You must have prior experience in installing self adhesive wall paper. This not a big job but I’m big on the finish being perfect. The measurements are 90cm width x 130cm height. The application tool was included with wallpaper but if you have any other tools which may assist, i.e. cutting equipment, please bring them.

Replace 10-15 treated pine balcony boards. You will need to measure up, buy the boards, remove the old ones and take to the tip. Happy to pay hourly rate, pls confirm how much per hour you charge. Bunnings in Mornington is about 10 minutes away. Need to be done this week, earlier the better. Timing flexible to suit you.

Completion of a “build a shed”. It’s in a confined space, and will probably need two people to put it together.

We have a cupboard in our laundry that has new panelling and now the cornice needs replacing. One side will have to go over the wood we have inserted there (totally understand it will have a step and are happy with that). The other side will need to be halved I think?? We have the cornice, just need it cut and fitted. Happy to paint it ourselves afterwards.

i need a cabinet box to be made white finish look to cover the switch power box in a shop

I noticed water stain on the cornice after rain and would like to invite an experienced handyman/roofer to have a look and quote. Must be licensed and insured.

At both of my toilet bowl there is a built up stain. I would like stain remove and for it to be white.

Major Issues to be fixed: - Misalignment of cabinet doors - rusted joints (in some) - built in (integrated) fridge - disconnected door Below are just few pictures to illustrate There are lots of cabinets

Adjust height of hanging cabinet to fit my fridge.

Note - budget isn’t what I’m expecting to spend, please provide quote for 4hr labour and we can adjust later if it is going to take longer :) I need a tiler concreter or handyman of some sort to even out the slab in our house. We will be loose laying hybrid flooring over top. Part of the living area was an extension so there’s a big crack through the middle, at one end the two slabs are almost level so it’s mainly the crack to smooth out, gradually the extended area falls to the other end where it is maybe 20mm difference. Need the gap sealed and the floor level Please quote for labour with an estimate / hourly rate as I will buy the levelling product you need to save having to guess how much to allow for materials. Crack is 4490mm in length. The smaller slightly sunken slab piece in photo is 1640mm wide. I would prefer the job to be done sometime between 15th-17th. 18th or 19th possible if necessary. Thanks!

Looking for someone to quote replacement of wooden sashes x 5 that have been damaged by weather. This is for the quote only, actual pricing of job TBD upon review / measurement of job at hand.

Install a shed 1.52m(w) x 3m (l) x 2m (h) 1) Supply and Lay concrete slabs - I have worked out the configuration to take into account the spans (various sizes 600x600x38mm to 300x600x38mm). The ground has been cleared, may still need some levelling/compacting. See photo. 2) Assemble shed: https://www.simplysheds.com.au/factory-clearance-garden-shed-3m-x-1.52m-double-door-in-dark-grey.html 3) Bolt shed to slabs.

Convert a deck into a fourth bedroom. Second level of a residence in New Farm.

My kitchen needs a bit of work including broken cabinet and making more storage. I also thinking about getting new stove. Anyone willing to come in and inspect? Preferably on Wednesday or Sunday

I want this dog house assembled and extra wheels screwed on. I have bought the dog house and wheels. For complete transparency, you will need to carry the Flatpack box from ground floor to level 2 via stairs. Unfortunately I can't assist as my knee is dodgy. https://www.bunnings.com.au/pinnacle-1037-x-660-x-700mm-pet-shack-dog-kennel_p3440171 Location is 4/168 LYGON ST Brunswick east.

Need bathroom cabinet installed on a tiled wall (and also the screw holes filled in, on the tiled wall, from the old mirror where the new cabinet is going) PLUS need two 5cm holes drilled into the side of a steel laundry sink for access for washing machine inlet hoses.

I need someone to remove the wooden bench top from my IKEA Tornviken kitchen island. This is because I'm trying to sell the island but it doesn't fit out of the door with the benchtop on! It was assembled with an impact drill, so you will need to bring one with you to remove it.