Find experienced local tradies in Reservoir South

Supply and install approximately 25m2 of 10mm Aquachek plasterboard to walls only (including taping, joint and sand) - Walls are already plum - Cornices will be going in eventually

There are several small holes and small dents i need repaired before I move out next week.

2 skylights need flushing. 8 external corners, 8 internal corners, Beading installed already A few mitred joins. I can sand it.

Whole house needs to be replastered and painted

Looking for help to remove square adhesives and fix up tears on the drywall of my small studio space. Quite a while ago, I put up really cheap acoustic foam on my small studio space using cheap square adhesives. It of course, started to fall apart very quickly and the adhesives didn’t stick. I started taking them down but did a VERY bad job and peeled some of the drywall. It’s been left in this state for years and is very unsightly.

Awning window not opening, it seems the top of the window is dislodged from the top of the frame. Looks like the window needs to be reseated. Window winder brand new, already replaced.

Looking for a fencing guy to be able to do retaining walls and timber pailing fence,pls message me your best reasonable day rate

Town house that needs awning fixed. Whenever I pressed the extend button on the remote, the awning makes a clicking noise as if the motor is trying to turn but it doesn’t move.

Install plasterboard to cover bulkhead and small wall section. Reinstall existing 1950’s cornice and patch/repair. Tape and mud all joins, 2 edge strips required. Cabinet in photo will be removed and small timber frame bulkhead to be created.

Install awning on brick wall. It is 2500mm x 2000mm and hand crank.

Plastering approx 250 sqaure meters of house. Some walls and ceilings.

Pipes needed fixing in ceiling (plumbing issue) so now have about 6 holes that need plastering.

Carport wall - exposed at the back - birds are living in them!! Would love for them to be covered.. Estimated 276x162cm

We have taken some walls out and need areas of the roof and walls replastered to fill the gaps. It is a decent size job. You will need to bring equipment and new plasterboard. I have some off cuts left over that you can use as well.

I would like plastering and cornicing of the ceiling in my workshop. Approximately 10m x 5m

Need a plasterer to plaster walls and ceiling of an hallway L shaped hallway and a boxed in doorway. Boxed in doorway is 820 wide and 2150 high Dimensions of hallway in picture, ceilings 2500 high

Hi - I need two holes in my bathroom patched. They are roughly 48x59 and 62x29. I have tape, compound and stud adhesive you can use. You’ll need to supply the gyprock sheet. I will take care of any follow up sanding or additional compound needed after the initial application.

Install outdoor awning x1 -- 1.5*2 meters dimensions. Parts provided. Ground floor.

Timber slat awning to be built. Hardwood, something durable for exterior. Finished with exterior timber stain. Please see my very average diagrams attached! Pic 1 showing length of awning to run right across front facade, and over the entry width to join up to the verandah. Can include a post for support if needed. Timber to waterfall down on right, to finish just off the ground. See last pic. Current awning to be removed. Price to include labour and materials. Listed price is my cc limit linked here. Any further costs to be negotiated prior, and would need to be paid separately. Located in reservoir

Need a plasterer to help with a few plastering tasks 1. Repair plaster walls in the kitchen and laundry taken out during demolition. Add R4 insulation 2. Build 2 small stud walls for two places where the doors were taken out. Add R4 insulation 3. Patch a few cracks on the wall and cornice and have an even finish 4. Patch a wall damaged by door knob due to not having door stopper 5. Patch a ceiling hole