Find experienced local tradies in Kellyville

looking for a licensed and insured carpenter /tradie to repair and secure an external timber pergola/awning that is pulling away from the main house wall. Scope of Work: Secure Structure: Properly re-attach the timber beams to the rendered wall/internal studs to ensure it is structurally sound. Waterproofing: Flash or seal the gap between the timber and the wall to prevent water ingress. Finishing: Close the visible gaps, ensure everything is level/flush, and touch up the paint/finish to match the existing structure. Requirements: Must be a licensed tradie with experience in structural timber work. Must have own tools and tall ladder/scaffolding if required.

Disassemble a Sauna, or if possible pick up the whole thing and put it on a truck. Weighs 220kg 1.3mx1.3m x2m high Pickup location: North Kellyville NSW 2155, Australia Drop-off location: Kellyville NSW 2155, Australia Removals size: House Stairs: No

Hi  I'm querying the cost to dismantle a 2 person snlighten mpulse sauna. Going from North Kellyville, 2155 to Kellyville 2155 and reassembling it. Kind regards Chelsea

Looking for an experienced plasterer for a neat repair of 3 small internal damaged areas in a home. -damaged section of plaster wall approximately 20 x 10 cm. -damaged plaster around a working power point (repair is to surrounding plaster only; power can be isolated during works if needed). -small damaged wall corner / edge near the skirting. I’m looking for the plasterer who enjoys neat repairs. Please include repair and final paint make-good in your quote, with best possible colour matching to the existing wall. I can supply paint, or reimburse you the costs if you provide the appropriate paint for the job. Please confirm: • experience • painting / paint-matching • materials supplied • earliest availability and today strongly preferred. Photos attached.

Looking for an electrician or experienced handyman to replace a few cracked wall plates in my home. Work required: • Replace 1 x light switch wall plate • Replace 2 x double power point wall plates • Ensure all switches/outlets are secured properly and sit flush against the wall • Check everything is working correctly after installation The existing plates are cracked, so they just need swapping for new ones. Wiring should remain the same. Photos attached showing the current setup. I'm happy for you to supply the replacement plates (standard white) or I can reimburse for materials. Flexible with timing but would like it done sometime this week or next. Prefer someone with electrical experience (licensed electrician ideal) since power points are involved. Should be a quick job (likely 30–60 minutes).

Drywall needs to be patched in few places and then painted over. Also need spot painting in few other places while we wait for patch to dry. Only paint will be provided. Thanks

Need to install the awning on the brick wall. It has been assembled but may need some adjustment before installing. Its a 4 by 3 meter awning . Below is the link to it. https://www.factoryfast.com.au/products/motorised-outdoor-folding-arm-awning-retractable-sunshade-canopy-grey-4-0m-x-3-0m-1?variant=43388842016953

I moved in a house and there are no cupboard, I wanted to make atleast 10 cupboards big ones. Please let me know.

I want a gibrock trades man to build a small room in the main hall which is very big. and also we have a big garage and we need to add gibrock to make couple of storage rooms.

I am looking at rendering the house and paint white.

We had a leak in the ceiling due to a plumbing issue which has been fixed. However some of the gyprock is damaged and needs to be replaced. Approx size is 1.5m X 1.5m. The area needs to be painted white after gyprock has been installed.

Repair and re-render facade cement render . Flexible on timing Must do a nice and quality job. Have min 4 star ⭐️ rating Must ensure no damage to property and also area cleaned Needs to be arlyric render

Tesla Gen 2 charger installation in Garage,3 phase meter is other side of the house(photos attached)and add one power point Alfresco area.

I need plastering service.

Need to mount one TV of size 55" on a gyprock wall. Bracket available, hidden wire required. Need the job done by tomorrow (Monday) before 4 pm. Happy to pay $80.

I’m looking for a licensed and insured gyprocker to carry out ceiling patching, sanding and sagging repair work in my home. The ceiling was a glue only job, so if current gyprock can be screwed to the ceiling battens. Most rooms are currently empty with minimal furniture, so it should make access and clean-up slightly easier :) Rooms Overview Kitchen (The room mostly affected by sagging): Remove and replace approximately 6 square meters of gyprock ceiling. Open to suggestions here…. Living Room: 2x old oyster light holes & 1x speaker hole Dining Room: 1x AC vent, 1x oyster light hole, 1x speaker hole Garage: 2 x AC vent holes, 1x old speaker hole, 1x downlight hole and 6x old screw holes. Laundry: 1x oyster light hole & old fan hole Bedrooms (x4): 1x oyster light hole each room) Hallway: Patch light hole Prop and screw: Garage, 4x bedrooms Requirements - Must be licensed and insured - Quote must include all labour and materials - Clean, professional finish required All areas need to be finished and ready for me to paint. Quote to include all labour and materials.

Installing awning in backyard. 4*3M

Small gyprock patching. Ready for painting

I need 5 extra power points installed, one fixed (looks like a blown fuse) and fix a ceiling light. I in a single storey house with both ceiling and under house access.

I've to get 2 walls and 1 pillar rendered before painting them. Walls are of approx 2.4x2.3, 2.3 x 2.4 and pillar 2.3x0.3.