Find a professional lattice installation service near you

Need front stairs painted, has had some white paint on the balastrade but we gave up due to lack of time. I have the 2 paint colours (sand and navy), need more white though. Obviously happy to pay for more supplies where required! Stairs will need to be prepped prior to paint as it's covered in leaves/probably needs filler and a light sand. I've included 2 photos of the stairs before so you can see the colour set up To confirm it's a double set of stairs with two landings. The underneath needs to be painted as well to match. The property is high FYI. Rear deck has had horizontal panels/privacy lattice installed. Need these all painted plain white.

Looking for a reliable and experienced handyman to install lattice panels in our alfresco area. The purpose of the lattice is to add privacy and a bit of shade. Materials (lattice panels and brackets) can be supplied, but open to quotes that include supply and install. Please note: I have provided sample green lattice installation we found online and looking for similar setup.

Repair patio plastic roofing and lattice structure after storm. Photos show damage, please quote for repair and any materials required, confirming if it can be repaired or entire roof needs replacing. Patio is approx 6.5m x 5m

Build and install lattice, trim away current hedging in the way.

1. Wooden lattice with climber is falling down and needs removal 2. Side gate is also broken and needs replacing

Need to have some lattice screening replaced.

Attaching timber lattice to timber paling fence. Approximately 8m. Would suit someone with nail gun. Lattice already purchased

Need someone to build a lattice above a concrete block fence. 5.5 meters long x 40 cm high.

We need to add timber lattice top of existing fence for neighbour's privacy. We need to do for 12m total.

Thick, quality, charcoal shadesail fabric possibly custom made to be fixed around carport as privacy wall-screens down 2 sides and across one (road) end only (not house-end; this to be left untouched) to be off floor and possibly just below carport roof (you decide) with said outer road-end made into a 2-door swing-in fabric covered lightweight gate-frame, or lattice pieced gate-frame (or other lightweight method?) for rare brief single car access (carport used for seating area). My EasyShed flat roof 2.25mW by 0.78D by 1.82H (arriving soon) to be put up by you therein resting on thin pavers you recommend. Photo is not my single carport but is same, also as those seen in distance opposite. Note: all double carports are for two houses to share being divided down middle by two steel pole supports at either end ie the double carport seen in far distance is for two houses to share, as is mine. Only half of the double carport, including its shared middle section, is to be screened and gated. Carport measurements are: 450m/177" = the 2 down sides (each) and 300m/118" = road end going across (for your custom-made gate across bottom). The carport roof at outer edges (from ground) is 207m high, at interior 210m high. Suggested lattice (if not making fabric covered gate-frame or other method?) for double gate, is perhaps: Bunnings Jack Matrix charcoal plastic reeded diamond lattice; sizes include: 2410 x 1205 x 5mm 2410 x 1205 x 7mm 1800 x 1200 x 7mm 2400 x 600 x 9mm None of the carports are screened. Mine will be the first. As I have no frame of reference to guide me, any knowledgeable advice, economy saving tips, and helpful suggestions will be appreciated.

Remove 1 damaged lattice panel. Install new panel ( provided). Repair one damaged lattice panel. Dispose of rubbish. Adjust one sliding door.

Replace the fence lattice around 10 meter on brushwood fence.

I am looking for somebody to install timber lattice/trellis like this one from Bunnings: "Lattice Makers 2400 x 600mm Treated Pine Lattice" (https://www.bunnings.com.au/lattice-makers-2400-x-600mm-treated-pine-lattice_p0362690). Please note I have not bought these already, I would like you to supply what you think would be the best fit. I would like these installed securely on top of my side fence, lining up with my back fence (to match the purple lines in the first photo). In total, the dimensions would be approximately 40cm x 800cm.

Need a painter to do two coats of paint for balcony, railings, balustrades, staircase and gate, lattice. Balcony size is approx 11 metres by 3 metres. See photos. Painter to supply all painting equipment. We can provide the paint.

I need to spray paint 15 x 2.7m pieces of Lattice in UV monument pain before being put up on the fence. Drop sheets required.

Reattach lattice to brick wall that has come loose. Holes are already drilled into the wall, need 3 wooden stakes reattached to wall with screws and ensure it’s secure. Will need to work around a spa and garden bed with trees

Dig a hole to install lattice in front of rainwater tank. Stakes to be put in ground to hold lattice in place. Three jasmine plants to be planted at the base of the lattice. Small border to be put around the jasmine plants and an echinacea plant that is already in the ground.

Reattach lattice Seal around window check roof for leak.

I need 6-7 new posts to support these 3 large lattice panels. They were supported by a wooden fence which has now been removed by the neighbours. The posts should be approximately 2.1m-2.6m tall (the land slopes a little bit) so they can support the lattice at both the top and bottom of the panels. The total size of the lattice panels is approximately 6.5m x 1.1m The lattice starts at approximately 1.3m above ground, and the top of the lattice is approximately 2.1m-2.6m above ground. A colourbond fence is planned to be installed by the neighbours sometime between Xmas and New Years so it would be ideal to do this job asap before the new fence is up for easier access.

Install a panel as per photo using the existing post on the right and using the fence rail( inside of fence) and dynabolt to driveway floor using bracket to install another post to the left . Then fixing panel aligned with other panels to the right. It will be easier when you see the job. Ladder provided if needed. Please work quietly as is my elderly mum's house and do not be bothered by nosy and unfriendly tenants renting next door. Just focus on the job and u can not go on their property. You might want a quick look first and if different screws or bracket is needed I can purchase ready for installing. The panel is quite long so when fixing you can temp use a screw to hang one side to make it easier when securing the other side . You can work it out, an old man attached the three panels to the right on his own in a few hours. Just to be clear the panel is to be installed inside the black gate to the left towards the inside gate.