206 Internal door installers in NSW

Need 3x internal doors in my unit replaced, and old ones disposed.

Installation of one internal door, same as pictured on the left of the image provided. Door and hinges on-site ready to go

Install 3 internal doors (2 bedrooms + 1 bathroom) Hinges and privacy levers provided Semi - Solid Door (as shown in the photo)

Install 6 internal doors with handles. Replacing old with new ones.

Looking for a person with carpentry experience to assist in a project gone wrong. Door is 2010 high and 260 wide and has been reversed. Looking for someone to fix the hinging issue and patch and paint the door. Hinges will need to be replaced (existing ones measure 100mm in length but are too bulky for door. Existing hardware to be used. Paint provided.

I need two internal doors replaced. I have bought solid wood doors to replace hollow doors on two internal rooms. The hardware etc will also need to be installed

Looking for an experienced chippy/handyman to replace 8 internal doors (hollow core) Doors are supplied Hardware is supplied Painting not required Doors will need to be trimmed to length - handles + hinges installed (non-mortise hinges) I will dispose of old doors.

Cut down one internal door by a few mm.

Hang an internal door. Door is too tall for doorway (approx. 2cm) so needs to be power sawed. Door hinges also on the wrong side of door so need to be switched to other side. Note: pics show door upside down (so hinges look to be on the correct side).

Measure and install internal doors.. one in garage and 2 in bedrooms

I need about 50 mm shaved off the bottom of a wooden door and then have it re-hung. I need this job done urgently within the next two hours.

Four existing doors need planing to open/close easily. plus I need a new door hung.

$100 Fee listed is a placeholder. Please read listing to completion. TASKS: Remove existing internal doors x 7 (6 x hollow core, 1 x wood+glass). Install new x 7 Solid Core (Corenthian HMR solid particleboard core) doors. 2040 x 820 x 35. Ensure smooth operation, alignment, no scrapping etc. Install door levers / handles. IMPORTANT NOTES: Doors jambs appear to be standard size 2040 x 820 however the odd door may need some minor trimming. It's an old house, not much is square, so i cant rule it out is all im saying. Existing door jambs are metal with 2 internal welded hinges (house built in 1979). See attached pictures. I am not sure if an additional hinge will be required to support the extra weight of these solid core doors. I propose to install with larger/stronger screws using existing 2 hinges first then assess if it seems OK. I think it will be. For example 10G 30mm. I have some Otter 10G x 30mm Satin Chrome Hinge Screws from Bunnings that can be used or if you have better recommendation please advise. The door jamb are very solid as all walls including internal are block/brick. As the door core is particleboard, you must ensure to always drill appropriate pilot holes first. Painting not required (will be done later). Disposal of old doors not required, although you are welcome to offer if nominal fee. I will supply: - The new doors - Door handles/levers - I can provide other items if advised in advance. - I can assist with lifting/holding doors on request. You will supply: All tools, experience, other items necessary to complete the task. Happy to list job for 1 door only and settle the rest via direct upfront agreement. Date and time is flexible but ideally within the next 7-10 days. Location West Pennant Hills 2125

We have a hold in the door which we need repaired, filled, sanded and painted. Approx 12cm by 8cm at largest points

Need a carpenter or experienced handyman for the following - - Replace 7 interior door handles - Install 4 new magnetic doorstoppers against skirting board - Realign loose cupboard hinge (replace hinge if necessary) - Remove 2 sticky doors from hinge, shave down and reinstall I will supply door handles and doorstoppers. Can reimburse for hinges and screws as required.

We have 5 skylights above internal doors that don’t open…we need someone to make them operable (they will need something to hold them open)

3 Internal doors need to be trimmed due to new carpet having being installed this week. Need tradesperson to measure how much to trim, trim door and hang again. Doors have been removed from hinges. Doors are located on first floor of 2 story townhouse. I can help to move doors. Outside area available to work on doors.

Plastering Required Above Internal Doorway and Light Fitting (as per photos) I need a plasterer to assist with a small project in my home. **Task:** - Plaster a small hole above an internal doorway. Plaster the area for a light fitting, so care must be taken to work around it. Experience in plastering and patching walls. - Must provide your own materials and tools. - Clean up after the job is completed.- **Timing:** - Looking to have this done as soon as possible. Please provide your availability. I have the light fitting to be fitted after plastering work is done, so electrical experience required.. Either this Friday, Saturday or next Friday, Saturday. Thank you!

Need internal door installed. Date flexible New hardware (hinges and knob/latch) already on site New door will need to be cut down slightly . Hole will need to be installed in new door for knob and latch New door dimensions 820x2040 Existing door dimensions 808x1990 approx Pictures are of new door and existing door/hinge Price of 123 a placeholder

Laundry door needs to be shortened for new flooring and the lines on two washing lines need replacing