Find an experienced handyman in St Ives NSW

The timber beam in the roof cavity shows visible cracks at the joint area as in the photo. Task involves checking the structure, reinforcing or replacing the damaged section and making sure it is safe and stable.

Hang 8 dual roller blinds in bedrooms: - 3 x 180cm x 210cm - 3 x 150cm x 210cm - 1 x 90cm x 210cm - 1 x 210cm x 210cm

I have a ceiling fan that’s wobbly and want to replace it. I brought a new fan already. So this job is for the required labour and parts for replacing the old fan with the new one.

Hole in wall, needs to be patched up and painted.

I need someone to install awning on the wall - 5.5 metres long. Already purchased the awning, just need drilling and installation.

Code UC38FM39 3480mm width x 2400mm drop (recess) Light Filtering Lining- pair of curtains Hand Drawn Slimline Track Face fix brackets

To Install the following items; Install and a new twin basin sink and connect to the existing utility pipe or if needed change configuration to fit, sealing gaps and securing sink to the benchtop. (See photos of sink and existing pipe) Install a rangehood and connect to power. Both power outlet and ducting are behind the plaster board at the present. Rangehood comes with its own ducting. (Rangehood as per photos) Install a 900mm gas cooktop and connect to existing gas outlet or if necessary configure to fit and using appliance-grade silicone sealant to secure cooktop to the benchtop. All works to come with a warranty and trade person to be fully licenced and insured. This job is inclusive of parts to be supplied by trade person which will be some PVC pipes for the sink and a gas hose for the cooktop.

The strings that attach to the roller blinds are off the tracks or the mechanisms need repair

Have 3 small chips on the edge of the kitchen bench top. Need them repaired.

Reyractable fly screen on two double garden doors

Need someone to fix my dell inspiron laptop, the hinge on the right seems broken, screen is totally fine, now can’t close laptop!

Need to replace my manual lift door with a section panel motorised roller door. You must: - remove old door - remove upper timber storage - increase height of replacement garage door from current 2.2m to 2.4m Current door is 2.2m high by 4.8m wide. Take height to 2.4m and maximise width by removing side timbers on the bricks, should free up 100mm each side. Installer to supply, install and remove all waste of current garage door panel. Open to free quotes

repairs/replacement of kitchen cabinet doors - 1x 6' with 5 hinges and 2 smaller doors with 2 hinges

My 2 wooden window blinds are cracking, need repair

I need an Avanti multi station gym setup disassembled and then setup at Silverdale

Small dent repair on the drivers side door. About the size of a $1 coin

The render at the bottom corner of the house has broken off and there are some cracks.

roller door at the gerage need to repair cause the steel rope of both side are disconnected

We have 3 sets of gym lockers that need to be assembled. Fortia gym lockers - Metal lockers

A dining chair that has a broken leg needs to be repaired. Please see attached pictures.