Find trusted local electricians in Melbourne City CBD

Looking for someone to do fridge maintenance. Front display fridge has blown out the electrical socket and requires maintenance. We need this done ASAP.

Looking to add 3 or 4 extra power points in my apartment.

Looking for battery installer for my house

Experience electrician with insurance and certificate required

Replacing electrical oven. The old one was connected directly. The new one has a plug. Need connection with certificate.

Half of my house lights not working Location mickleham

We recently had electricians complete some work in our apartment and there are a couple of ceiling holes that now need to be properly repaired and painted. Looking for someone experienced in plaster repair and painting to make good the areas so they blend back into the existing ceiling. Details: • Apartment located just off St Kilda Road • Standard plasterboard ceiling • Photos attached for reference • Ideally you supply materials (filler, primer, paint etc.) Looking for a clean finish that blends in well with the ceiling. Flexible timing, preferably in the next few days.

I'm looking for an electrician who can disconnect & remove the electric heater from the wall safely. And also run cable through the wall to mount the TV on the wall. This job is inside an apartment.

Install a small cheap water heater cheapest possible please

Replace the power board which was slightly broken.

5 PowerPoint switches to be changed, one is 3 switch, 4 2 switch - I have the new switches purchased and ready to go

Electrician Required Disconnect power from reception desk Melbourne CBD. Power connected behind a drawer into wall.

Hi, The power has tripped in my apartment. Need it to be checked to see if the points are ok and then turn it back off on from the main complex room (building manager will give access)

Remove 4 old oyster lights and install 2 new pendant lights + 2 new oyster lights from IKEA.

The buttons on two power switches (which I have marked) cannot be pressed down anymore. One switch is for the washing machine and dryer, and the other one is for the shower room

We have wired Ethernet throughout the house in a recently built apartment tower. The Ethernet port in one of the rooms has been pushed “through” the plate and is now hanging in the wall, and I can’t plug anything into it.

Got a new IKEA paper lamp to be hardwired and installed onto our ceiling light. We have the cord set and bulbs all ready.

Install a power point on the wall or a power access in the roof.

Melbourne CBD Warehouse apartment conversion Loss of power to power points and for hot water. Lighting is ok. This occured following the heavy rain earlier in the week and some water entered the apartment. The switches don't appear to be tripped. Unsure if this affects the levels below or only level 2 (top).

Supply and install downlight. Diameter of the hole on ceiling is 9.5cm. No socket plug ready.