Find a reliable appliance technician in Seddon West

I need someone to remove my old existing dishwasher and need new dishwasher plugged in and pipe reaffixed.

Install of rangehood. Just needs to be screwed in, plugged in and the setting checked and adjusted if needed. Old one was pulled out, this has been test fitted. Should be no more than 10-15min of your time.

Breville Barista Express - when press coffee function it blows the fuse. The water and steam wand work fine. Machine 8yrs old but otherwise no issues. Due date: as soon as feasible

Electrolux DX302 dishwasher showing a flashing light and an E10 symbol, now with water leaking out of front door and refusing to drain. Wash cycles are interrupted every few minutes by the error

I have an oven and a electric cook top, oven i need reconnected and a fixed range hood screwed in. Took them out to replace cupboard doors and kitchen bench. Going back in same spot

Need remote control programmed to the garage roller door for our apartment. See photos attached for the roller door motor type. The motor is up quite high so will need a ladder to reach the motor unit.

Dishwasher IKEA built in Electrolux Lagan. Water not getting hot. Model number 60475627. Cycles completing but no hot water. Urgently want repaired

my dishwasher has blockage and needs to be fixed xx

a glass broke in my dishwasher causing it to have a blockage in there. help need fixing it

there is a blockage in the area and it needs to be fixed. it won’t take much of efforts as a glass broke in the dishwasher causing the water to get blocked

Ariston dishwasher starts but doesn’t fill with water. Need diagnosis and repair.

The grinder stopped working. I cleaned it out, descaled and reset. Button still sounds like it clicks

Diagnose and repair dishwasher not filling / possible AquaStop fault. Dishwasher starts, makes a slight buzz, then beeps and does not draw in water. Model: Artisan / Ariston LFT216 (under-bench dishwasher) What I’ve checked/done: - Cleaned internal filter - Sink water supply is working normally - Followed clog troubleshooting steps from a video/manual - Suspect fill issue / AquaStop inlet hose-valve fault - I can’t safely remove/access the rear panel where the inlet/AquaStop connection is Important symptoms: - No click from the AquaStop box/hose at the start of the fill stage - Alarm beeps about once per second - No flashing wash cycle lights visible (manual mentions some faults should show flashing lights) What I need: - Fault diagnosis and repair (or quote if parts are needed) - Check inlet hose/AquaStop valve assembly, inlet filters/mesh, fill valve circuit, and any anti-flood/float issue - Advise if AquaStop hose/valve needs replacement Please only respond if you have experience with dishwasher repairs. Because this involves water + appliance electrics, I’d prefer someone appropriately qualified/licensed for this type of work in Victoria. Please include: - Experience with dishwasher repairs - Call-out/diagnosis fee - Whether you can source/quote parts if required

The fridge part of my refrigerator is warming up while the freezer part is still functional. It seems like the vents between the freezer and the fridge are slowing being covered with ice. I have defrosted the fridge overnight twice and it has started working but then has frozen over again. Fridge is a Westminster virtuoso

Dryer is on brackets on a wall, quite heavy and I want to stack it on my washing machine rather than have on the wall

Leak coming from underneath. I have checked the hoses. They seem okay

Its jura impressa f8, needing grinder cleanout and service. I can drop it off to you if you lolike?

Refrigeration mechanic or appliance technician required to repair a 2-door bar fridge that is producing warm air. I have already changed the thermostat which has not fixed the problem. Fridge brand is Bar Fridge King.

I need help installing a new dishwasher, including hooking up and making hole in cabinet for pipes. I’ve hooked up the same way as my previous dishwasher however the water isn’t running when I turn on the tap (only slow drip) so need someone more familiar with dishwashers to help connect. Photos attached of the water fittings at the tap. I also need a larger hole cut in my cabinet to allow for the pipes to sit lower so they fit in the back recess as they currently block the dishwasher from sitting back far enough.

i need the dishwasher removed. It's only small. Then I will take it to Bunnings for a refund. Later I will need a new one installed. For now I would like help to remove it and load it into my car