Find a reliable appliance technician in Abbotsford VIC

Our coffee machine is is blocked, dispensing coffee very slowly / almost not at all. I have attempted to clean it however it hasn't seemed to work

The dishwasher keeps trying to pump out water even when it is empty. There may be a leak with water going into the drip tray or maybe there is a valve that needs replacing.

My Bosch washing machine is showing an E18 error and won't drain — water is left sitting in the drum at the end of the cycle. Looking for an experienced appliance repair tech to diagnose and fix

Looking for a licensed gasfitter to extend the existing natural gas line that currently feeds my kitchen oven by approximately 1 metre, penetrating the rear external wall to terminate with an outdoor bayonet point for a BBQ. Existing supply: natural gas, currently connected to the kitchen oven Scope: extend the line roughly 1m, core through the rear external wall, install outdoor bayonet fitting, pressure test Must hold a current Victorian gasfitting licence (Type A). Certificate of Compliance required on completion. Please confirm the existing pipe and meter have capacity for an additional BBQ appliance before quoting, and flag if a new run from the meter is needed instead. Location: Abbotsford 3067 Happy to be flexible on timing.

Very quick job to tighten the water connection from the tap to the washing machine. It's all set up but the screw needs to be tighter – currently leaks water when turned on.

Cistern repaired - doesn't refill after flush Power point replacement Downlights replaced Door shaved

Looking for someone experienced with Smeg dishwashers to diagnose and repair ours. It’s making an unusual noise and appears to have a drainage/error issue. Looking for someone who can come ASAP.

The front loaded washing machine drainage impeller is stuck. Debris is stuck wrapper around the impeller.

Switch needs replacing. It’s a 2 position switch. I will have the new switch here. Free coffee when you’re finished! 😊

I would like a dent removed from my fridge. My delivery guy dropped it. Devastated!

Smeg oven hinges have fully extended, not sure how to fix

My Rocket Apartmento is not working properly. Need it fixed asap

Require a gassfitter or plumber with gasfitting endorsement to safely disconnect oven gas line etc in order for kitchen to be removed and line made available for next kitchen install.

I have a Standesk electric sit-stand workstation that needs a repair. The desk was working fine, then stopped after being moved a short distance. The electric motor can still be heard running, which suggests the issue is likely a loose or disconnected internal connection rather than a motor fault. I've spoken to the distributor who advised removing the bottom plate and checking the connections inside. I'm looking for an electrician or someone with demonstrated experienced with electronics/appliances to come and inspect, diagnose, and ideally fix the issue on the spot. I can provide the original assembly instructions.

Washing machine is leaking coming from beneath the machine and needs to have dryer pulled out (I can help) to be examined for leak source. Depending on type of leak I will pay extra for repair.

gas safety check that needs to be completed by a plumber. We require the reports and certificates by a registered plumber.

Just bought a new Bosch range hood and need the old one removed and the new one installed. The new unit is smaller than the existing one and might need some tinkering with the exhaust ducting -- not sure until the old one is removed. (I don't have the specs for the old unit and couldn't get them from the manufacturer bc the model is too old). Also looking to replace a light in the shower. Nothing exciting.

Washing machine keeps smoking when the spin part of the cycle starts. I think the drum is rubbing against something

The buttons on my dryer are playing up. Somethings it doesn't trun on and it stops mid way through its cycle. I think it needs a new control board

Our Gorenje integrated refrigerator beeps every 24 hours reflecting the left side freezer is not at temp. Doors appear to be sealing fine. No issues on the right side. Hoping for someone with Gorenje parts and experience to troubleshoot the fault and fix.