Find a reliable appliance technician in Werribee

Hanging bulb need fixing and power point need fixing in the microwave area as it doesn’t seems like electricity is passing through this point

Replace heating element in the technika hot oven

My LG inverter front loader is leaking water but not from the pipes (that I can see), it’s happening right at the beginning of the cycle. I could do with someone assessing and then perhaps fixing the problem (depending on parts needed), I would like this done asap.

Water is not releasing into dishwasher

Aldi dishwasher. When we turn it on it just beeps, doesn't start filling or anything. Hoping someone that knows what they're doing can come out and fix or advise.

Connect gastop stove brass pipe and connect waste pipe. After 4pm prefered. Thank you

I just need a gas stove connected. Previous gas stove was leaking after pressure test was done (connection has been capped as in photo) so new stove bought and needs connecting.

Pump is not working, needs fixing

Fridge has PCB board issue needs replacing or repairing.

I need a safety & compliance check of all gas installations and fittings within the property - Kitchen gas stove and gas water heater

I have a Shark PowerDetect vacuum cleaner with a powerhead brush roll that is no longer operating. Would Fix myself but do not have the time. Symptoms: * Front headlights show a solid red light. * Brush roll does not spin at all (no attempt to start). * Suction appears to be working normally. * Brush roll rotates freely by hand and is not jammed. Troubleshooting already completed: * Removed all hair and debris from the brush roll. * Cleaned the PowerDetect sensors. * Opened the powerhead for inspection. * Checked visible wiring and connectors for damage. * Cleaned dust from internal components. * Allowed the unit to dry after possible moisture exposure. * No obvious signs of burnt components or damaged cables. I’m looking for someone experienced in vacuum cleaner repairs or small appliance electronics to diagnose the fault and repair it if possible. I suspect the issue may be with the brush roll motor, wiring, or control board within the powerhead. Could possibly be the sensors too but doubtful. Please let me know: * Your experience with Shark vacuums or appliance repairs. * Whether you can diagnose and repair on-site or need the powerhead brought to you. * An estimate of diagnostic and repair costs. Model: Shark PowerDetect (exact model can be provided upon request).

Install my dishwasher to the kitchen water and drain. New house, all water inlets and drain system in place

my Miele front load washing machine is not working properly and it keeps coming up with waterproof fault

Oven is not stopping, seems sensor issue.

My Samsung BubbleWash 8.5kg front-loading washing machine has stopped mid-cycle and the drum is now locked. It won't complete the cycle or unlock. I have just moved house so could have been during the move that something went wrong. I need an experienced appliance technician to: • Unlock the drum safely • Diagnose the cause (likely door lock, drain pump, or sensor issue) • Complete a basic service/clean • Replace any small parts if needed (I'II cover parts cost) Machine is easily accessible in Werribee. Prefer someone who has had experience In Samsung front loaders.

Hi, looking to get my 90cm Technika Gas cooktop replaced. I have already bought the cooktop. If you are available after 5pm today or tomorrow would be preferred. I am located in riverwalk Werribee Thanks

Wasnt able to tighten washing machine onto tap, tap is leaking (needs new washer we believe) and washers for hoses.

I am looking for someone to INSTALL my new Rubber insert on my front loader washing machine. Werribee AREA- I have the part already. Just need labour.

Need new tap for dishwasher. House is on stumps. Most probably tap connection will come out of floor. Existing tap is coming out of wall above benchtop.

Fisher & Paykel front loader - clear filter fault - water doesnt drain properly - spin cycle is rattling quite loud - had the same fault even after clearing filter