Find a reliable appliance technician in Parkville VIC

Think the emergency lock was pulled to hard and door won't lock on Bosch Serie 6.

1. Install a dishwasher, needs repiping under the sink 2. Replace washers on inside taps 3. Install new shower and bath taps / head 4. Look at feasibility of adding a garden tap in front yard Looking for hourly rate and materials

The fridge is not cooling

Measure electric cooktop and install a new one.

We’ve got a blockage in our Bosch dishwasher. Looking for some help to fix.

The washer keeps displaying 4E error every time I start the load of clothes

Level washing machine to sloped floor drain

Need washing machine disconnected at 7am. Model - Samsung8.5kg-6kg Combo Washer Dryer WD85T984DSH.

Supply and install a 250 litre grease trap in a small pizza/cafe.

I have taken apart my oven door to clean in between the glass and cannot correctly put it back together again 🤦🏻‍♀️ as part of an end of lease clean Issue is that I’ve screwed everything back in as best I can, with the metal rods that are meant to secure the inner glass layer, but the inner glass layer isn’t properly secured. I’m thinking it’s something I’ve done wrong with screwing in the metal rods the wrong way and so it means they can’t secure the glass- I just can’t figure it out, but am thinking it would be quite simple for someone who has cleaned an oven or two in their time!

The fridge model is SR341MLS

I am changing the layout of my kitchen and the stove is changing wall. The rangehood therefore needs to be relocated and the associated ductwork needs to be adapted and extended. I have exposed the walls and ceilings - revealing a metal ductwork system and several pipes in the way from the apartment above. The solution I think is to remove the existing in wall ductwork, seal up the existing ductwork branch to this and then add a flexible duct to the existing duct. Photos attached help a little but I expect this will need 1 visit to work it out exactly and then a second visit to carry out the works. In the photo you can see the duct is on the far wall, but in the new layout the stove will be on the short return wall on the right.

I have a Samsung washing machine: WW85T554DAW/SA. The metal ring with springs came off from the rubber seal, and the water leaked. The rubber seal seems to be okay and is still attached to the machine despite slight damage (assumably) made by the metal ring when it came off. Can anybody come and re-place the metal ring please? Or if required, with the replacement seal and/or the ring which I doubt it though. FYI I have a dryer stacked on the washing machine and because where it is situated (next to the toilet), the door can't be wide open. Not sure if it is normal, if I pull the seal, I can't take off the whole seal but I can place the metal ring around the seal.

Need cameras installed on concrete and timber surfaces. Total of 3 not cable connections

Clean the filter of my washing machine

Gas stove disconnection and capping as well as kitchen tap and wastewater capping to enable safe demolition. Apartment. OC approved. Needs to be done by certified plumber. Reposted as didn’t include kitchen tap before. Could be today or tomorrow. Thanks

Dryer brackets are installed into brick in bathroom. I would like to get the brackets removed and wall patched.

The top two of the electric cooking top are not working. Parts not included. Thank you!

2/4 cook top not working. Can smell gas and can see the speak but not lighting up. Need help to fix it

Need to install a washing machine in the apartment