Find a reliable appliance technician in Inner South Melbourne

Moving house. Need plumber to connect up top loader washing machine to hot and cold water.

Home filtration system installation

The bearing on my 18kg Samsung washing machine is faulty. Is there anyone who can repair it?

Hello, The rotating bar underneath the treadmill has come out of position & likely needs to be lodged back in. At this stage, I don’t believe any replacement parts are required. Thanks

Install rubber seal and two wire rings on rubber seal on front load LG washing machine.

I need someone (with experience) to connect my gas bottle (CGA320 head) to my soda stream (TR21-4 female). I have the hose and necessary implements. Every time I connect it, the gas bottle just leaks C02 and doesn't pass through the hose. Rendering it all useless. Not really sure what I'm doing wrong. The deliverable must be the fully functioning connected gas bottle to the soda stream. I'm happy to pay for any extra parts required.

Install a 60cm slideout rangehood. I already removed the old one. Timber duct build in above the unit duct with an outlet to the outside. Electrical plug in is in place.

I need the range hood installed as the kitchen guy did not measure it properly it does not sit straight in, also I need a whole cut out for the smoke to go out to the vent you will need to come out in person to look

I'm looking for a qualified/ experienced plumber to diagnose and repair a water leak under my kitchen sink that comes from the connection between the dishwasher water supply line and a copper pipe/fitting underneath the sink. Initially the leak only occurred when the dishwasher was running, but it has now progressed to leaking whenever the cold-water supply valve is turned on. Details: -Cold-water isolation valve currently needs to remain turned off to prevent leaking. Hot water works fine. - Dishwasher currently unusable. Looking for someone to inspect, identify the cause, and repair properly. Repair may involve tightening/replacing a compression fitting, olive, valve, hose, or other plumbing component as required. Please bring any common replacement fittings that may be needed. I've attached photos of the current setup to assist with assessing the job. Location: Caulfield South, 3162 Preferred Time: Wednesday morning, preferably within the next few days.

Electrolux fridge (ELUX529L Bottom Mount Refrigerator) currently leaking - can hear water trickling pretty constantly and water is pooling under fridge. Otherwise, fridge seems to be still working for now as it is still cool inside (displaying 2 degrees). Need someone to assess the situation ASAP and ideally fix if possible. Located in Glen Huntly Thanks

Help me untwist the hose from tab

"Need dishwasher swap: Remove Whirlpool ADP6000WH, install new Bosch.make sure it works. Prefer removal of old unit."

Our motorised folding arm awning is not retracting as it should, and we have been advised it’s likely because the motion sensor batteries need replacing. We require someone with a ladder and tools to locate the awning’s motion sensor/s and replace the batteries (3x AAA batteries, provided). Instructions included in the photos section. Would prefer someone with experience in servicing motorised awnings in case other repairs may be necessary.

Our tenant used the washing machine and a bar underwire is now stuck under the drum

I need a plumber to replace my kitchen sink tap (tap supplied) and connect my washing machine drain hose extension (supplied for you too) to existing under-sink plumbing. All plumbing points already in place. Straightforward apartment job.

Hello! When I moved in, the washing machine was connected to the hot water tap. I need it switched to the cold water tap please. The connection is just too tight for me to unscrew myself.

Need a tap changed in laundry sink and washing machine stoppers changed

I need someone to drill a neat access hole in the side panel of my laundry cabinet so the washing machine inlet hose can pass through to the water tap located in the adjacent metal cupboard. Please also fit a white plastic grommet for a tidy finish if available. I gave it a go before realising my drill bits were for wood only 🤦🏻‍♂️

My Bellini dishwasher is showing an E4 error and has stopped working properly. It powers on but comes up with the E4 code during use. Looking for someone experienced with dishwasher repairs/appliance servicing to inspect and fix the issue.

Hi, seeking a skilled Airtasker's to install a dishwasher with existing fittings - dishwasher will be supplied - please include experience to do the same and your available on May 22nd May - will accept first reasonable price - thank you