Find a reliable appliance technician in Fitzroy North

Our built-in dishwasher has gradually shifted backwards into the kitchen cabinetry and is no longer sitting flush with the surrounding cabinets. Looking for someone to: * Inspect the installation * Pull the dishwasher back into the correct position * Re-secure it to the cabinetry/benchtop as required * Check that the door opens and closes properly afterwards As far as we’re aware, the dishwasher is working normally and there are no plumbing or electrical issues. This appears to be an installation/mounting issue. Please bring any tools required. Experience with built-in dishwashers, kitchen cabinetry, or appliance installation preferred.

The oven is not heating up. Normally takes 9 minutes to reach set temp of 180 degrees, reaches it in 1 minute but not hot, maybe on 50 degrees.

My Fisher Paykel dishwasher won't start. When I try to turn it on it makes a few beeps and doesn't start. I believe it's an issue with the door latch.

Need someone to fault find Filter issue with Bosch dryer. It runs for 5 mins then filter light comes on. I have cleaned out the lint filters. See pictures

Washing machine smells like burnt rubber when off and when on. BOSCH. 7 YEARS.

Bosch dishwasher not heating water. E02 symbol keeps flashing.

Hi Jonathan, we've got a gaggia classic pro that is not flowing well. I am also a mechanical engineer haha, but I don't have the time to go deep on this. I've descale, a bit of a clean, but the flow is still poor, I think it might be some scale in the solenoid which has tipped this over into outsource territory. Would you be able to help with this? We're located in Fitzroy North, just next to alexandra parade. Thanks! Kev

Disconnect oven gas/electric and make safe. Move oven to front home exterior ready for removal.

Have an under bench fridge that needs to be re-gassed and maybe minor work

To inspect the pipes under the sink in the kitchen and to provide an itemised quote to see what needs to be done to install a washing machine next to it.

I have the new seal and new one is mouldly. Need someone who know how to do it! Brand: Miele * Model: WWG660 WCS * Type: HW20-W * M-Nr: 11407330 * Made in Germany

Service of Washing Machine Make is in the image. The machine has begun spinning very very loudly and vibrating through the building. It has also begun leaving grey marks on clothes. It seems as though something may be loose? Otherwise it still washes clothes, just it almost seems like it could break at any time, It’s due for a clean & service.

My fridge has stopped cooling and was hoping someone could fix it. It's a sharp but I don't know much about the model.

Dismantle- mounted TV, vacuum bracket and washing machine.

Our fan isn’t spinning and needs to be fixed as soon as possible please

Fix washing machine, machine is making loud noise when using and clothes are dirty. Need someone to take a look at it and potential maintenance before I purchase a new one

Our miele Dishwasher won’t pump out the grey water. Our plumber has checked the pipes and they are all clear and sensor is working - we think it’s a pump issue.

I have a Samsung front-load washing machine (AI control model) that powers on, but the touch control are not working. Issue Detail: Machine turns on using the touch power button, dial works fine to select wash cycles, start/pause button does not respond, none of the other touch buttons e.g. temperature, spin respond, no error codes showing. I nee someone to repair the fault.

My bowling machine is broken. I have had it for about a year now and when it is put up to the highest setting it just stops I can’t get it to work. It is an electrical problem within the motor and I don’t know what it is. It would be 50 dollars for turning up and 100 if it gets fixed plus any required parts

Need some help with a fridge that is leaking water from the bottom and not keeping a cold temperature. We believe the drain might be blocked but would like some help with this! Located in Fitzroy north and are flexible with dates and times - hoping for next Wednesday the 14th or Friday the 16th. Thanks so much!