Find experienced local roofers in Central London

Leaking joint on external PVC down pipe above 1st floor. I have Gorilla wet tape but ideally you will provide additional sealant. You will need to provide your own ladder, tall enough to access the joint which is above the first floor window (see photo) The pipe is on the front of the house.

The gutter has detached from the wall and may require a new bracket and the gutter needs 2 ends reattached to each other with a screw. this is on the first floor

Need insulation on two walls in our studio to reduce noise traveling between lessons and also from a gym next door.

We have a gutter above the first floor that is leaking heavily and likely needs a repair as it was cleaned very recently and that had no effect.

The down pipe has become disconnected from the gutter (top centre of the pic) which means it leaks during heavy rain. It's a small job but quite high.

Gutters just need a clearing. Please bring tall ladder as it's the roof is on a first floor maisonette.

The gutter has detached from the wall and may require a new bracket and the gutter needs 2 ends reattached to each other with a screw. this is on the first floor

Please see the attached images of our current drainpipes - we are looking for someone to use a wire brush or an angle grinder with a wire wheel to remove all loose rust and old paint, apply a rust converter (Hammerite which we will provide), apply a metal primer (re oxide primer which we will provide) and finally paint two coats onto both drainpipes (we will provide the paint) - the drains need some TLC but it is only surface rust which we would like to be tidied up, the pipe is not leaking etc. We have ladders and scaffolding to reach the drainpipes. Any questions let me know!

Gutter seems to be blocked as it overflows. Suspect squirrel activity.

I need to get this pipe fixed - basically the join has worn away so it needs sealing back up - it would ideal if a plumber could look at this.

Gutter needs clearubg, causing water ingres

Old raidiator pipe in way of putting furniture flat to wall

One of our downpipes has come loose and needs to be reconnected.

Leaking gutter between two adjoining pipes causing water to run down walls and damp inside of house. Gutter is leaking at point of joining the down pipe.

To create a new 1.2m high wall both sides of the chimney breast in the bedroom. And then shelving above. At the moment there is shelving all the way up on one side of the chimney breast which will have to be partly removed I would have thought or maybe the wall can just be made over it.

Builder has opened up the inside of a chimney stack in our kitchen. The front and top area has been covered with timber. Need someone to install a 90cm extractor hood, fixing to the timber, connecting to the extraction duct. (already installed) and electrics (wiring already installed. The extractor hood is Smeg KSG9P4X 90cm Stainless Steel Canopy Cooker Hood

Need layer of torch on to be placed on top of shingles, as they have leak.

A cast iron downpipe (it has three sections) replaced with a mock uPVC equivilant (I have the replacement parts). Once fitted, it needs to be left open/at a slight angle, since the underground drain it connects into is blocked and needs to be unblocked by a separate drainage specialist.

Various roof repairs, including slates, repointing chimney stacks and parapet walls. Flashing might need small repair. The kitchen at the back has a flat roof on which a ladder can be placed. There is also a flat roof section on top of the house which can be accessed from the flat roof on top of the first floor back room. Cat ladder may be necessary, or cherry picker or boom lift. You will need to visit to see if you can manage without scaffolding.

Clean gutters and at front of house and re connect down pipe