Find experienced insulation contractors in London

2 tasks for a competent carpenter: 1. Create a narrow hallway console table with 2 legs like the 3rd image below from a solid beech wood table top 200cm length x 20cm wide x 3cm depth and solid beech legs 85cm high. (we have the table leg connectors and brackets to hold in place on the wall). We need the table top to be routed at the ends to softly rounding the 2 front corners (around a 15–20 mm radius) and taper the underside in a gentle 45° chamfer for about 15 mm. Task 2, to cut and fit x 2 60cm wide x 240cm high oak insulation panels to a wall.

Insulate the extension walls and install plasterboard, ready for plastering. Remove the existing foam layer from the ceiling, then fit new plasterboard throughout the ceiling, leaving all surfaces prepared and ready for skimming. Ensure all boards are securely fixed, joints are properly finished, and the area is left clean and ready for the plasterer. Supply amd fit

Looking for a handyman/carpenter to insulate and internally finish a 15ft x 8ft timber garden shed/summer house. Scope of work: Install insulation to walls and roof (foil/multifoil or equivalent). Tape and seal insulation joints where required. Fit thin plywood (approx. 3–6mm) or similar boarding over the insulation to provide a neat finish suitable for occasional home office use. Floor does NOT require insulation or covering. Shed dimensions: approximately 15ft x 8ft. Please note: This is not a full garden office conversion. No plasterboard, plastering, skimming, decorating, electrics or floor works are required. I am simply looking for the walls and roof to be insulated and neatly covered with thin plywood (or similar sheet material) to provide a clean, practical finish suitable for occasional use as a home office. Looking for a tidy finish and completion within a day - can extend into second day for final touches if needed, Please quote for labour ONLY and share material cost estimations

Install lost insulation and fill holes

Lay 100mm insulation between rafters, and 170mm insulation on top to insulate a cold loft. Small amount of loft boarding to be fitted too. Old insulation to be bagged and removed. New wool insulation and loft board will be on site, so fitting required Loft space is approx 40m2, and low headroom

Removals of Loft Insulation and Wooden board.

Looking for someone to install a bathroom extractor fan and insulated ducting. I already have the extractor fan and insulation/ducting materials ready, so this is a labour-only job. The tan will be installed in an upstairs bathroom with ducting running through the loft. Looking for a neat, professional installation to help improve ventilation and reduce condensation. Please provide a quote for labour and let me know your availability. Thanks.

I need my garden office insulated, laminate flooring installed and painted inside.

An area of the loft needs boarding up so can be used as a wardrobe. The door needs moving back and a new partition wall added. The roof has old insulation that needs replacing. Some wooden floor we have left needs putting down in a v small area to match.

I live in a ground floor flat and my living room is by the front door. The neighbours above make a lot of noise when entering and leaving the house.

Help a carpenter for a day installing insulation and plasterboard to walls and ceilings.

I need 2, 1.2 m blinds put up on my wall over the windows it is URGENT this is done as soon as possible as it is getting extremely hot and my room is sun facing so my room is hot. Preferably someone with their own drill and tools it’s IKEA blinds so everything comes in a pack.

Hi there, I started renovating my summer house myself but unfortunately don’t have the time to complete the project, so I’m looking for someone to come in and finish it properly. Work required includes: * Roof insulation to be completed (walls have already been partially insulated) * Internal cladding of the walls/ceiling with plywood * Lino flooring supplied/fitted * Installation of a proper secure lock on the door * Window beading to be fitted/finished * General touch-ups to the existing paintwork using barn paint to make everything look tidy and finished The structure is already in place and some of the prep work has been started, so it’s mainly a case of completing and tidying the project to a good standard.

Remove old insulation from loft and put in a new one

* Light cleaning (dust/debris only) * Remove old insulation * Supply and install new loft insulation * Please include waste disposal in your quote * Confirmation if insulation material is included

1) Carefully remove all floorboards downstairs and set aside. 2) install timber battens between joists 3) install rigid insulation minimum 50mm thick between floor joist, above battens. 4) underfloor heating pipework installed between joists (materials supplied by us). Joists to be notched where required to allow pipework to pass through 5) dry sand a cement mix screed to the placed between joists above underfloor heating pipework and levelled flat. 6) fix down floorboards over the top of all, fixing floorboards into the joists.

2 toilet seats installation electrical bidet

Shed insulation and bit of planters work Inclusive of tax, not charging any additional fees

Remove the old Insulation and boards. Clean up the loft thproughtly and install new Insulation (270 mm) and raised floor boards (using loft trac or loftzone)

Insulate the indoor ceiling of a lean to conservatory with conservatory cladding/panels