Find experienced local tradies in South Brisbane

Our glass panel, inserted into the stair panel, suddenly shattered without any impact. The size of the glass is 1050 mm (width) x 850 mm (width). I have attached the picture with this message for your reference. Could you please provide a quote to replace the equivalent glass and the installation timeline? Kind Regards,

• Task: Repair and patch a hole in an internal wooden bathroom door. • Issue: Door has a visible hole/damage that needs to be filled, patched, and finished so it looks presentable again. • Location: Indoor bathroom door (standard internal door). • Urgency: Needs to be completed before next week Thursday. • What I can provide: Photos of the damage, measurements, and any extra details needed. • What I need from the Tasker:• Confirmation that the repair is possible • Materials included in the quote (filler, sanding, paint, etc.) • Estimated cost and time required • Availability within the required timeframe

I am looking for an experienced tradesperson to renovate two brick fireplaces. Each unit is approximately 2.6m (H) x 1.16m (W). The scope of work includes: Rendering: Apply a smooth render over the existing brickwork for both fireplaces to create a flat surface. Painting: Paint the top section (above the mantel) with standard wall paint (color to be confirmed). Tiling: Install tiles on the mantel (the protruding part) and the entire lower section . Preparation: Protecting the surrounding timber flooring and curtains during the process. Specifics: Dimensions: 2.6m High x 1.16m Wide (per unit).I will provide the tiles and paint. Welcome all offers

​Hi, ​I need a qualified or experienced renderer to render TWO (2x) internal brick fireplaces, as shown in the attached. photos.Each fireplace is approximately 2.6m High x 1.6m Wide ​Finish required: A smooth, paint-ready finish is required. Corner beads must be used for all external corners.welcome all offers.

We have an old home under renovation which has very old style thick render. Needing patches done around the home before painting

I have two story brick house and need help with rendering

Needing door frame plastered and prepped ready to paint.

I am looking for an experienced renderer to render the front faces of two outdoor stairs. Dimensions: Each stair is 12.5 metres long by 20 cm high. Total Area: 5.0 m2 (2.5m2 per stair). Scope: Prepare the surface of the stairs. Apply a smooth cement Square off all edges and ensure a clean, professional finish. Clean up the site upon completion. ⚠️ VERY IMPORTANT: • We will be installing artificial grass soon

Install 2–3 standard power points. Existing power nearby. Easy access.

Hi, I accidentally clipped my rendered mailbox and need it repaired. Scope of work: - Repair chipped render (foam visible underneath) - Match existing texture (important) Colour match paint - Re-level / stabilise mailbox base (slightly shifted) Notes: - Standard foam/render mailbox (not brick) - Looking for a clean cosmetic finish so damage is not noticeable - Flexible timing but sooner is better

Need to render outside of new door that was installed in a brick wall going out to a new deck. If we can render the door frame flat, then we will paint.

Roofing/flashing repairer required to inspect and repair water ingress issues in 3 areas of a house/carport. To address the source of water ingress, reseal/waterproof the affected junctions, and replace any locally damaged fascia/trim where required. Large-scale replacement works are not expected unless clearly necessary. Part A – Carport corner/pillar Water appears to be entering the corner above the brick pillar, causing the black fascia/trim board to rot, with staining/runoff down the pillar. Required: Inspect and identify likely entry point Carry out targeted resealing/waterproofing of the junction/flashing Remove and replace the damaged section of fascia/trim if needed Make the corner watertight Part B – Front awning/patio roof Leak where the metal awning roof meets the house wall. Required: Inspect roof-to-wall junction Reseal flashing/joints as needed to stop water ingress Part C – Rear awning/patio roof Similar issue to Part B, but along a longer section. Required: Inspect leak points Carry out targeted resealing of flashing/joints as needed Ensure water is draining away correctly Photos attached. Please quote for the repair work needed to make the affected areas watertight. If any larger replacement works are considered necessary, please explain why and provide that separately from the base repair scope.

Correctly plug hole with plaster and small paint over 50cm x 10cm strip where old light fitting used to be

Fix up a bit of plaster work and paint after. Only ceiling of main bathroom and ensuit.

Need a handyman to fix, sand and paint two small holes on the plasterboard wall.

I need to put 5-6 power point

$250 for first point including call out fee. $150 for additional points. We will work with you on practical locations..

Scrape down and apply two to three if required coats of acrylic lowsheen woodland grey to stairwell, screens and balustrades, no filling just coating, no overspray or drips anywhere else. Ideally nook and cranny roller and brush, materials supplied. Two gates, road side only

Put up a metal house sign approx 1 m long on a newly rendered wall and 2 metal numbers on a tiled wall.

SEEKING PLASTERER WITH PAINTING EXPERIENCE. Need a Plasterer to complete a 3/4 finished Reno job that my sick tradie is unable to complete by Sat 31st Jan. Following to be done. -Complete another layering on 3x bedroom walls -finish plaster work and paint to completion (bedroom, hallway, kitchen)