Find experienced local tradies in Parramatta

Small patching and creating a small box around a frame 300 by 300 mm

Looking for a handyman or plasterer to repair small gyprock/plasterboard dents and chips in a wall. Minor patching, sanding and paint touch-up required. Located in Westmead Prefer someone experienced with clean, professional finish. Please message with availability and quote.

Need a small knock patched and painted around a light. See photo. Paint match and paint required.

I need to replace the bottom half of a gyrpock wall. Approx 1350 mm high by 3600mm wide. Need it sanded and prepared for painting. Also need a small section of the ceiling patched up (refer pic). Will be replacing light with downlights so need it closed off and prepared for painting. I have other small patch work to be done which we can discuss. You will need to supply gyprock.

Need 3 curtain rails installed from ceiling or gyprock walls. Rails are already cut to measurements

Need to install one balustrade glass as its broken. Approximately 1.25 mtrs *1.15 mtrs glass balustrade needed to be measured accurately, made and installed..

Looking for an experienced handyman or insulation installer to replace damaged ceiling gyprock and install foil insulation under the roof (as per attached photo). Scope of work: • Remove damaged ceiling gyprock • Supply and install new gyprock/plasterboard • Tape, set, and sand joints (ready for paint) • Install foil board / sarking insulation under roof rafters (like existing in photo) • Secure insulation neatly between timber framing • Re-inforce the rest of ceiling and set finish. Clean up and dispose of waste

Repair Small Square in Gyprock approx 5.8cm in Wall and patch holes from Air Conditioning and Two approx 3cm Holes in Brick Wall

Then say gyprock works , angle bead for plasterboard wall was damaged , need repaired or new panel Site visit also if needed

A section of plasterboard has sagged/collapsed. Remove and replace damaged plasterboard or reuse if possible. Tape, set, sand, and paint to match the existing matte white ceiling finish. Reinforce the area (joists or fixing points) to safely support the existing curtain track and heavy curtains – suggestions welcome. Care needed around recessed lighting, air vent, and window/curtains. All materials (plasterboard, compound, tape, paint match, any reinforcement timber/screws) to be supplied by the tasker. Clean up required – vacuum dust, protect floors/furniture.

Need one external power point to connect wall fan on the deck Nearby points are garage, backsideof the wall is kitchen switch board boards Brick wall outside

Hi, I need to hang two wall mounted hangers (per photo). I’m after someone that can detect the wood behind gyprock so the hanger is drilled into wood, not just gyprock.

Seeking an awning to be hung on external window. One bracket has already been hung but seeking a speedy completion of job as opposed to my slow DIY skills. Window is approx 3m in height off the ground.

Need holes for mounting retractable clothes line product Need to be careful of plumbing and electrical behind one wall face Failed to drill using DIY Ozito hammer drill

Hello! 👋 I'm seeking a qualified/experienced handyman to hang two framed glass prints on an internal wall—locating studs or metal framing will be required. Items: 2 x glass prints, 50cm x 75cm each—they're reasonably heavy, at best guess, around 6 kg each. If it's of any value, the items were purchased from Snapfish. (I have also included a photo of the provided instructions.) Wall type: I believe it’s gyprock/plasterboard. The tradesman who mounted my television in another room concluded that our walls don’t have timber studs—he suggested metal studs/framing behind the gyprock. If it assists with your estimate, our building is slightly less than five years old. Requirement: Please locate studs/framing and mount securely—not just into plasterboard. As such, please bring a stud finder and supply appropriate fixings for plasterboard and metal studs. Finish: I'd like the items level, aligned, and evenly spaced. I'm happy to follow your recommendations. Access: Normal apartment/home access. Underground parking can be provided, as needed. Timing: Ideally, after 11:30 AM on Wednesday, 17 December. Please include in your offer: • Your experience with heavy wall hangings and plasterboard/metal studs. • Confirmation you can mount into framing or use appropriate heavy-duty anchors if needed. Many thanks, in advance.

We need to fix few holes in the ceiling photo attached not that big, nice and tidy look required of our ceiling I am in Granville

I’m looking for a licensed electrician to install an outdoor weatherproof power point for a new heat pump. Scope of work: • Install 1 x outdoor weatherproof GPO (power point) on the external wall in the location I’ll show you. • Existing internal power point directly behind the desired location, and • Another existing power point approx. 10 metres away on the same wall outside. • Power board is 15 meters from the desired spot. Preferably a dedicated/isolated 15A power run via conduit from power board, which is approximately 15 meters away. • Outdoor power point unit will be supplied by you. • You to supply all other materials: cable, conduit/trunking, fixings, etc. • Test the circuit, ensure it’s RCD‑protected, and provide any required certificate of electrical safety/compliance. Requirements: • Must be a licensed electrician (please include licence number in your offer). • Experience with external/weatherproof power points. • Clean, tidy work and must make good any small penetrations made. Timing: • Flexible on day and time – ideally within the next 1–2 weeks. Please let me know: • Your approximate total price (labour + materials, excluding the power point itself), and • When you’re available.

We have knocked out an old wall, i am looking for a plasterer to close up the gaps and finish of the gyprock work. Supply all tools and materials. IMPORTANT NOTE: Building allows minimal noise. No power tools can be used, any cutting or mixing needs to be done by hand in door, all works need to be done extremely quietly.

Need to render 2 walls. Doesn’t need to be perfect finish

I need new gyprock installed in bathroom, which is 3m x 2.5m x 2.8m high