Find professional cornice repairs in NSW

Looking for an experienced plasterer to complete gyprock and stopping work in a renovation room. 📍 Scope of work: One wall – narrow gap to be sheeted and finished Wall approx. 5140mm (both sides) → Around ¼ already sheeted → Remaining to be sheeted + fully stopped Wall approx. 1750mm (both sides) → Sheet + stop Corners & returns throughout to be finished Ceiling height: 2490 Ceiling patching required → Room width approx. 4200mm → Previous walls removed, so ceiling needs patching (either full sheet or sectional patches – happy for you to assess best method) 🧱 Materials: Please supply all materials (gyprock, compounds, tape, cornice, etc.) ⏰ Timing: Prefer job done ASAP Ideally completed by Friday next week so we can paint ✅ Looking for: Someone experienced who can deliver a paint-ready finish Own tools + tidy workmanship

Looking for an experienced painter to paint a new plasterboard and cornice. Details: Area size: approx. 6.0 m * 3.0 m Ceiling is newly installed plasterboard Includes ceiling and cornice Scope of work Apply 1 coat of sealer Apply 2 coats of flat Ceiling paint Neat, professional finish with clean edges See pictures

I need the cornice patched afte the installation of a new rangehood to please

Plaster 16sqm of fyrecheck and install 10m of cornice. Only requiring setting of the fyrecheck. Will be ongoing work at different locations. Send your sqm rate.

I damaged the cornice when removing the surround for mirrored doors in a built in wardrobe. I am installing a replacement wardrobe and need the cornice repaired. There is no rush about timing. I also need the remainder of the surround wardrobe removed on the other side of the wardrobe cavity.

Remove cornice from ceiling and give ceiling the look of polished concrete. The ceiling is a solid concrete slab so no plants board. The cornice appears to be plata from the part I’ve tried to pull away. It comes off but crumbles rather than a single piece. I would like an industrial polished concrete ceiling look but unsure the best way to achieve this. Some options and ideas would be great. Ceiling size is 4.8m x 6.5m

Remove cornice from ceiling and give ceiling the look of polished concrete. The ceiling is a solid concrete slab so no plants board. The cornice appears to be plata from the part I’ve tried to pull away. It comes off but crumbles rather than a single piece. I would like an industrial polished concrete ceiling look but unsure the best way to achieve this. Some options and ideas would be great. Ceiling size is 4.8m x 6.5m

- Roughly 3m X 3m size - I will buy the gyprock, cornice and the plasterboard lift, need someone to install the gyprock sheets for me - I will do the paint job myself

Supply and install gyprock sheets to garage ceiling and supply and install cornice around. Must make it ready for painting Size of garage is 2750x8500mm and about 2100mm high

Looking for a plasterer or handyman to repair a corner section of cornice in a bedroom. The Job: > * Remove damaged section and install new 90mm Cove Cornice. One side is approx 18cm, the other is 27cm. Tasker to supply the small length of cornice and adhesive. Need the joins set and finished so they are ready for me to paint later. I have attached a photo showing the damage and the 90mm profile. Please let me know if you have any questions!

Install approx 18LM of 90mm cove cornice. internal corners = 7 External corners = 6 End infill = 3 Material supply and install to be agreed on Note walls and ceilings may not be flat, level or plumb.

Bathroom walls and ceiling lining

Cornice has bubbled up. As pic. One cornice is smaller than the other

There is a small gap in the cornice where air conditioner ducting was removed. I can purchase the cornice from Bunnings. I need it to be cut and installed and gaps filled.

I have a damaged cornice and part ceiling due to water leak from recent rains. I need them cut out and removed along with part of the ceiling so as we can locate the leak. After leak is repaired we would like ceiling and cornice replaced

The cornice in my kitchen has come loose and is separating from the roof/wall. Seeking someone to repair this for me

As previously mentioned. 130 square meters. No perfect edge required on the wall as I will paint the walls afterwards do you can just cut in about 100mm. I will move or cover furniture. Happy for you to view the job first

Install & Set Cornice (Approx. 800mm x 800mm Section) Looking for someone to install and set a small section of cornice as shown in the photo. Materials will be provided — just need your labour and experience. Scope of work: • Measure, cut and install cornice (approx. 800mm x 800mm area) • Set joins neatly • Fill • Leave area clean and tidy (I will sand and paint it) This is a small, straightforward job but I’d like someone who has installed cornice before and can achieve a clean finish. Time estimate: Approx. 1 hour

fix 3 spots where the ceiling cornices are damaged. One has been smashed, this is the photo where it has been taped over in white. The other two are existing cuts were previous built in wardrobes were taken out and replaced with new ones. Render one air vent that has been bricked in. White set tender finish this. Then render in gabs in brickwork in small hallway. It can still look like brick/textured but needs to be flat to make it easier to paint.

Cornice (standard size) supply and installation for 2 rooms (see floor plan attached for measurements). Bed 1 and 2. Coverings needed for furniture and carpet if sanding is required.