Find professional cornice repairs in NSW

Need a cornice replaced, approximately 275cm (this would need to be supplied, see photo of the most damaged area above the blind rail), and a few other areas requiring patch and paint. I have more photos available but can only upload a certain amount. The damages were caused by double sided tape and we need to rectify. We would be needing the cornice install and patch and paint to be completed by Wednesday 22nd July.

remove existing ceiling & cornice replace with new ceiling & cornice

Small piece of corners to be cut to size. I don’t know how to connect the corners. A shelve to be screwed into a wall. It’s just to hold It in place not floating

Needing someone to put some new cornice up.

Gyprock all exposed walls, bricked areas and ceiling in both rooms + Install cornices. Room 1 is approx 6.2m x 4m. Most of the walls are glass sliding door or windows. Some gyprock has already been started on far wall. Room currently being used as storage however will have all removed prior to job commencement Room 2 is approx 2.8 x 1.6m small room laundry We will supply all materials, cost just for labour.

I need 3 sections of Cairo 4 step (100mm) cornice replaced. 2 x 3.8m and 1 x 4.4m lengths. You source all materials. Any time of day is fine. All 3 are in bedrooms with standard 2.4m ceilings.

We had to remove some old ceiling cornice and we need someone to help replace it. We have the cornice already. Just need help to install it.

We want our current cornice to be removed and LED cornice to be installed. The room is roughly 6m ×3.7m We would want your advice on what material (cornice, led strip, adhesive) is required and prefer 2 quotes - one with all material supplied by you, other with material supplied by customer. Please let us know what photos and videos you need and we will add them to the job here. Ideally we'd like to find LED cornice thats similar to our current cornice. Photo of current cornice attached, and link to preferred LED cornice below (we are open to suggestions) https://cornicepro.com.au/products/the-canary-cove-modern-led-cornice-1

I need around 3.5 metres of cornice fitted , I have already got the cornice

Removing cornice from ceilig very easy to come off just stanley knife and rip

Part of our cornice in the bathroom (around 1.5 metres) has fallen off. We’d like it reattached.

2 m cornice and a small kitchen wall to be painted. Paint will be supplied.

We have 2 metres of cornice that needs to be installed above a closet.

Re-attaching a fallen cove cornice piece in picture . Clean old adhesive, applying new adhesive (like cornice cement or construction adhesive), and supporting it while it sets prefer no nails as I don’t want to repaint Its in one peice so should be easy to re glue

Plaster 16sqm of fyrecheck and install 10m of cornice. Only requiring setting of the fyrecheck. Will be ongoing work at different locations. Send your sqm rate.

Supply and install gyprock sheets to garage ceiling and supply and install cornice around. Must make it ready for painting Size of garage is 2750x8500mm and about 2100mm high

Looking for a plasterer or handyman to repair a corner section of cornice in a bedroom. The Job: > * Remove damaged section and install new 90mm Cove Cornice. One side is approx 18cm, the other is 27cm. Tasker to supply the small length of cornice and adhesive. Need the joins set and finished so they are ready for me to paint later. I have attached a photo showing the damage and the 90mm profile. Please let me know if you have any questions!

Install approx 18LM of 90mm cove cornice. internal corners = 7 External corners = 6 End infill = 3 Material supply and install to be agreed on Note walls and ceilings may not be flat, level or plumb.

Bathroom walls and ceiling lining

Cornice has bubbled up. As pic. One cornice is smaller than the other