Find trusted local electricians in Brunswick East

Electrician for kitchen renovation, townhouse in Brunswick East. 3 stories, kitchen on ground floor. New kitchen going in late July to early September, needs approx 5 staged visits: disconnection 27/07, rough-in 04/08, temp fit-off 14/08, disconnect for stone install 31/08, final fit-off 03/09 (dates may shift slightly with the schedule). Scope: 5x new double power points incl one flush-mounted in cabinetry and one designer flush outlet in tiled island, isolator switch, dedicated oven circuit (2.5mm2) and induction cooktop circuit (6mm2), LED strip lighting connection, rangehood connection with switch in cabinet, connect owner-supplied appliances (induction cooktop, oven, integrated rangehood, integrated fridge, dishwasher, microwave), disconnect/reconnect one existing point, switchboard capacity check. Detailed MEP plans available on request. Must be licensed (REC) and provide Certificate of Electrical Safety.

I need my tv mounted and cables hidden behind it with the installation of two double power points on the wall behind it. There is power close by to draw from on the wall beside it 2 meters away and I am ready and willing to help with the installation or anything else needed. Single story home with access to the attic and below the house.

Just taken over a small business and one of the down lights isn’t working. It flickers for a second when you turn it on then cuts off and flickers again about 10 seconds later. I require quotes on how much it would cost to fix it and I would also like some quoting on future work in the space

I need an electrician to convert a down light into a pendant light.

My smoke alarm won’t stop beeping and it’s too high up in my landing for me to reach, I don’t have a ladder and I don’t know what to do with it so would like someone to help fix it

Using power tools, drill a very neatly finished hole though the shelf, to pass a cable down to plug in microwave.

I'm looking for a local sparky who can do a very small job - shortening the cord on this pendant light. Must be licenced.

Lower a 46kg heat pump dryer down one floor via a void on ropes/straps (you provide) and install on shelf in laundry. Laundry is close to staircase/void on lower floor. Dryer will sit on hip height shelf. No drilling required. Must fix drainage hose (provided) that will drain into laundry sink next to dryer. I think this is definitely a two person job. We have had larger/heavier items lowered through the void by removalists when we moved in so issues with the dryer fitting. Just need two strong people with appropriate ropes/straps. The dryer is already here and unboxed. Pic 1 shows void next to stairs from above and pic 2 is dryer currently resting in front of railing in front of void.

Check of gas line for one stove and hot water unit with compliance certificate. Any repairs to be carried out same day if possible. Replace existing smoke alarm (battery unit, not mains connected)

I have an integrated fan and light unit that has fallen out of the ceiling in a bathroom. There is also an LED strip light in the same bathroom that needs to be fixed.

As per task added. Connect and add power points.

The bathroom switch only turns on the light the fan isnt turning on. I have two other light switches that dont fully click on too

We're preparing our 3 storey townhouse for sale, with a first inspection happening this Saturday Jan 24th. I've been replacing our smart MR16 GU10 downlight lightbulbs with basic warm white LED equivalents. There are two problems: 1. There is a set of four downlights on level two controlled with the same light switch, one of which is NOT GU10, but rather GU5.3. It had an old 12V 50W bulb in there, which was working but didn't match the colour temp of the replacement bulbs for the other three GU10 downlights in the set. I took it out and replaced with a GU5.3 5W LED bulb, but it failed to light up. Returned the original bulb to the socket and now it also fails to light up. Hoping to figure out what's wrong with the fitting and get it working before the first inspection on Saturday, if possible! 2. Also on level two, a MR16 GU10 downlight from another set is stuck, with the inner fitting refusing to budge when torque is applied. I figure I can still replace the bulb if I can get the whole housing out of the ceiling, but I know with the spring clips I run the risk of tearing a hole in the ceiling plaster as it comes out. This one isn't really critical, because the bulb in there is still working, but in an ideal world I could swap the bulbs without destroying my ceiling in the process.

We require two PowerPoints to be fixed. 1: Kitchen PowerPoint, one socket has stopped working. Black slimline cover. 2: Bathroom PowerPoint within cabinet, switch has become stuck. White slimline cover. We are looking for a qualified electrician to complete the work. Monday / Friday during the day or other days outside of hours is fine.

It’s beeping and needs to be replaced. I can’t get the cover off to take out the battery, see what size it is, etc. I need you to bring a battery. Please include in quote. Thanks.

1. Housing an external electrical power point for a roller door 2. Replacing a part on the front of a dishwasher 3. Removing 2 wall lights and replacing with different fittings

Hi, I require an urgent all rounder for the following: 1) Shower base - Shower base requires re-grouting Bathroom has no ventilation & requires high grade moisture resistant materials & workmanship. 2) Change light fitting - Source & refit oyster light fitting to match (refer to photo’s) brand name unknown, but component size is approx 27cm diameter adjunct on ceiling, cover is approx 26cm. This must match another in that room but If exact match isn't possible, then remove the same from bedroom & attach in lounge & supply another, style & light quality TBC. I’m not permanently at this property but a painter will be within the task time allocation, which may make access easier. Please refer to photos, forward any questions & quote accordingly. Offer is only to accept task, meet & greet. Thanks

Hello! I am looking for someone to change the light bulb in a down light in my bathroom (see attached photos). The building manager said it might be an E27 light bulb.

Need 2 new wall light fittings installed AND fix our electric roller door that keeps tripping.

Installing 4 wall lights Changing light switches Adding a dimmer switch