Find trusted local electricians in Sydney Eastern Suburbs

Need a licensed electrician to remove cracked broken ceramic cooktop and install new ceramic cooktop 60cm

Contractor went broke before finishing air conditioning install. One indoor unit needs power back off from the outdoor unit, and need 2 x Daikin controllers.

Replace a tcv plug and connectors on my landcruiser

Hi, I need a qualified, licensed electrician to run a dedicated circuit to connect a new kitchen oven. Scope of Work: * Run a new dedicated circuit from the main switchboard to the oven cavity (less than 10 metres). * Install 1x RCD-protected circuit breaker (RCBO). * Install 1x circuit breaker enclosure * Supply standard thermal cable (4mm²). * Hardwire and test the oven. * Replace the existing connection of the oven to the new circuit. * Issue a CCEW (Certificate of Compliance for Electrical Work) upon completion. Site & Access Details: * Access Type: Easy roof cavity access. * Switchboard: Circuit breaker enclosure is to be installed near and separate to the switchboard. * Appliance Specs: Mistral 3.25kW builtin oven. * Must hold a valid NSW Electrical Licence (please state licence number in your offer). * Must provide all materials (cable, enclosure, RCBO) and tools. * Must issue a CCEW certificate.

Connect a two wire intercom. The wiring is already there, it needs the monitor and camera connected. And replace an outdoor light near a bbq area

Replace heat pump on Bosch dishwasher. Error code is E09, so we assume it's the heat pump to be replaced.. Dishwasher is model Serie 4, SuperSilence 46db. Price is for labour. Please advise if you can supply the replacement part and cost of this.

Looking for a licensed electrician to disconnect a hardwired ceramic kiln from its electrical supply. The kiln is connected through an external isolator switch to a small distribution board, as shown in the photos. I’m removing the kiln and would like to retain the existing cable, conduit and isolator switch with the kiln. I only need an electrician to safely disconnect the electrical supply, test and make everything safe. I can remove the conduit and associated hardware from the wall myself once it has been safely disconnected. Located in Paddington, Sydney.

Replace 11 globes for down lights,

Hi, I need someone to help change the battery in a smoke alarm because it is chirping. • ceiling is standard height • would need to bring a step ladder and, if possible, a replacement battery – will reimburse the battery cost • would like to stop the chirping as soon as possible, ideally this weekend Thank you!

Attach a light fitting to the pendant. Minor electrical work - it just won’t fit over

We have a light that’s gone out in garage and need it replaced. We already have the new light. Just need someone to come do the work.

Hard-wired smoke detector making occasional piercing sound. Unsure what the issue is. Require qualified electrician to inspect and propose remedy.

Looking for a licensed electrician to install 4 customer-supplied pendant lights in an existing terrace house in Paddington. The pendants are opal globe fittings with cord suspension and are to be installed into/with ceiling roses. Existing ceiling lights and wiring are already in place at each location – no new lighting points required. The ceiling roses are already installed. Looking for someone experienced with pendant installations in older homes who can securely mount the fittings through/around the roses without damaging them, set the chain/drop lengths neatly, connect to the existing wiring, and test on completion.

I need to have both kitchen lights next to the exhaust fans repaired, as well as one ceiling light in the kitchen and one ceiling light next to the laundry area.

Replace old outdoor light fitting with a new one. Already provided.

Have two pendant lights to be installed replacing halogen downlights.

Yeah after the plug. No point doing that until done the plug. Could end up damaging the panel when it’s not actually damaged. JOB DESCRIPTION Need an electronic electrician to replace an RJ45 plug. Query broken RJ45 plug and/or an RJ45 socket. Soldering could be needed.

Hi, I require an experienced and licensed electrician to restore power to a powerpoint (two outlets) in my unit. One outlet hasn't been working for a while, and the other stopped working overnight. Today at 3.30 pm or tomorrow at 3 pm works well, but can be somewhat flexible. Thanks.

We have two ceiling lights that have never turned on and we want to assess whether its just the bulbs or a wider wiring issue. We need more light in this room so ideally want to change the ceiling bulbs and shades but currently have these very heavy, dated covers attached. Initial fee is for callout and assessment and we can negotiate total cost when we know what the issue is

Due to some wiring issue in a large apartment building, the bathroom light is on constantly. I need a second opinion on what’s going on which may require investigation of other rooms (removing and putting fans back on). Need a very experienced electrician to solve this problem.