Find trusted local electricians in Randwick

Looking for an electrician to move a GPO powerpoint as part of a bathroom reno. Wall is double brick exterior so has cavity. So do not want to chase walls. Also swap out the light/heat/fan switch with modern equivalent. Existing old GPO to have cover plate installed as won’t be required and not compliant with new sink location. Two new double GPOs to be supplied and installed where marked with green tick on photos (both new locations approx 300mm away from existing) New three gang light/heat/fan switch supply and installation. Preferably modern option.

Disconnect underfloor heating

-Exhaust fan 200mm needs replacing- currently connected to same circuit as light switch -Flip out rangehood installed incorrectly- blows out the back cavity -4 switch panel needs flipping- was wired reversed - replace 2 cover plates

I have 7 pendant lights I'd like to install. All the lights are here. Require a licensed electrician

Hi, I’m looking for a licensed electrician to install a picture light in my living room with a clean, near-invisible cable finish. Scope of work: • Convert a hardwired picture light to plug-in (add power cord + plug, ideally inline switch) • Mount the light centred above artwork on a plaster wall • Run cable down the wall to an existing power point (bottom right) • Install a slim cable cover/conduit and paint/finish it to match the wall so it is as discreet as possible Finish is very important – I’m after a minimal, high-end look (not visible cabling or loose cords). Details: • Standard gyprock wall • No existing wiring at light position • I can provide paint if needed (or happy for you to advise) Please confirm: • You are a licensed electrician • Experience with similar installs (picture lights / wall lighting) • What materials you’d use for the cable concealment • Total cost including materials

We need chandelier remove from ceiling and replaced with a downlight.

We have two PowerPoints on gyrock walls which are being removed, just need these to be put onto another wall.

I am seeking a licensed technician to diagnose and repair a large-capacity air conditioning system currently servicing a 10-room boarding house. The unit has completely stopped functioning and requires a professional assessment to identify the root cause—whether it be a compressor failure, electrical fault, or refrigerant issue—and a subsequent fix to restore cooling to all residents.

Rebooking task between Zoette Pty Ltd and Manogran

Hey everyone - looking to get air conditioning installed in my one bedroom, top floor apartment. Not wanting anything massive as the apartment itself is really small and contained so could be cooled down really easily. Please let me know what’s possible. Thanks! ** I haven’t purchased an air conditioning unit yet **

I need to change the socket on my wall in my gym studio to fit a technogym treadmil that runs a 15 amp plug

Daikin ducted system showing error U0-14. Indoor model FBQ71BYW4, outdoor RZAG71C2Y1. Green power light flashing. Likely outdoor power or comms fault. Newly installed system.

I’ve go 2 switches in my bathroom but only ones working for the down light so I don’t know what’s the other switch is for. also I’d need to install a power point for my bidet in the same toilet.

I have a lamp from the US I want to use in Australia. Needs an AU plug and advice on bulbs due to voltage/current differences.

Battery not charging this is an external battery to engine. I have it connected to alternator and also the solar

There is already a PowerPoint under current stove. Just connect new stove to it. Thanks

Hi we need an electrician tonight to install ceiling fan and connect to existing light switch. We will assemble the fan so it's ready to install and ladder ready to go.

⸻ 1. repair PowerPoint that is becoming loose from wall. 2. Install one or two new double PowerPoints. 1930s apartment (Sydney) Hi, I need a qualified electrician to install a new double PowerPoint on an internal wall in a 1930s double-brick apartment and fix one that’s come loose. Please quote including: • Supply + installation UPDATE In relation to the two new power points one is about 5 m slightly less From an existing PowerPoint actually the one that requires fixing, the other is about 3 m from an existing PowerPoint. The conduit would need to go up and around a door frame for this one. For both I need the new GPOs installed flush into the wall, not surface-mounted. Please use a proper brick flush box, cut a neat recess, and secure the outlet into the box so the plate sits perfectly flat with no wobble. Conduit must terminate cleanly into the box with the correct fittings. I’m looking for a solid, professional install that won’t get knocked loose. Can send photos of the potential locations. Photo of door frame you’ll need to go around now added. Photo of repair required attached.

Hang 1 x wall sconce (switch old electricity supply to new sconce).

We need an electrician to do the wiring for our pointpoints in kitchen before rendering. We also need downlights and fan installation