Find experienced local tradies in Weston Creek

Looking for a plasterer to complete the setting, sanding and patching of an existing renovation, ready for painting. All plasterboard sheets have already been installed, so no sheeting is required. The works include two bedrooms, two bathrooms, a walk-in robe and hallway, as well as five skylights. Looking for a good-quality finish throughout, ready for us to paint once completed. Located in Waramanga, ACT. Happy to provide photos of the current condition or arrange a time for you to come out and have a look before confirming a price. Please send through your availability and an indication of pricing.

Partial gyprock/drywall replacement in one room needed. The room size 3x3.75. Ceiling one line/sheet sagging. So it needs to be replace 1.2x3.7m wall 2 sheets + one small section. The wall has a door I will take architrave out if needed. wall 1.85 length up to wardrobe.so it is 1.85x2.43 wall 3m length has window 1.2x2.15m - 2 gyprock sheets celing 1.2m x 3.75m approx 1.5 gyprock sheets wall 1-1.5 gyprock sheet hallway approx 1 sheet sagging ceiling plywood 55mm cornice also needs to be replaced approx length: 2.4m + 1.8 + 3m + 1.6m

Looking for an experienced plasterer/wall-lining installer to install 6mm James Hardie Villaboard to the walls of a small ensuite renovation in Rivett. Bathroom is approximately 1.8m × 2.8m with 2.4m ceilings and is already completely stripped back to the timber framing. All electrical and plumbing rough-ins will be completed before sheeting. Framing, noggins and floor will also be completed. Scope: * Measure, cut and install 6mm Villaboard to bathroom walls * Cut around plumbing/electrical penetrations, window and recessed mirror cabinets (no niche) * Correctly fix sheets to existing timber framing * Leave tiled areas ready for the tiler/waterproofer * No ceiling sheeting required * No demolition required I can supply the Villaboard and fixings. Timing is important: plumbing rough-in is being completed 7 October and tiling begins 12 October, so ideally looking for someone available 8 October. Please let me know your experience with Villaboard/fibre-cement wet-area sheeting, availability and price.

Hi, we are looking for someone handy that can plaster drill holes on the walls of our house and make it look neat. We have about 5 drill holes. Happy to discuss if you use your own equipment or need us to supply.

Needing a room off our garage plasterboard . It is 3.5 x3.75 with another room 3.5 x2.1. Wanting this done cheap

Power point to be installed in a bedroom.

Patch two square holes in ceiling plasterboard done by plumber. Holes are approx. 200mm x 200mm each. They are near each other. No painting required.

Plastering Works for Renovation - 2x Bathrooms, 2x Bedrooms, 1x Laundry & 1x WIR - Approximately 180m2

Outdoor 3 person sauna. Assembly says 6 hours.

Minor plastering patchwork to fix holes in the ceiling. One in the bathroom and few other spots after removing the downlights (photos attached.

We have a brick fireplace in our living room, it’s been painted over white but we want to maybe plaster it to give it a more smooth look. We were also considering timber lining walls.

Our current bathroom was renovated 10 years ago. The tiles are large ones. We need to get it demolished and rendered in preparation for tiling.

Looking to get a quote to have my house rendered. Would like some options on colour/type

Plenty of walls i need repaired!

Gyprock/plaster board crumbling on bedroom wall - area 1m by 1m

Remove and dispose of wooden panelling and plasterboard from inside garage and from garage opening (where roller doors would be).

install two sliding built in wardrobes.

Repair holes, plaster and paint wall. Remove GPO cover plates (disconnected) patch and paint. I have paint

I pulled some ivy off my wall a year ago and it's left these remains behind. I've had some success removing them with a stiff bristle brush (which you can use) and water. You might have a better technic. Anything is fine as long as it doesn't damage the rendered wall (so I can't use a pressure washer). It'd be ideal if this could be done today (Thursday 19 Dec) or tomorrow before 330pm. Otherwise, still feel free to make an offer and we can find a time. I've captured all of the area in these photos. It's about 12m of wall in total. I have a ladder you can borrow which will lean against the gutter, but if you have a larger A framed ladder you might prefer to bring that for extra stability.

Recently had windows reduced in size, with new gyprock sheets installed to fill the space. The join seams of the new gyprock sheets need to be plastered and made flush with the existing walls so I can paint and finish the room. Images show all the edges that need plastering.