Find experienced local tradies in The Gap

Seeking qualified repairer to replace crank eyelet on house folding arm awning (approx 4.7m long), including labour and materials. Budget is a guide for labour and materials (eyelet).

Need a plasterer to patch three holes in a bedroom ceiling. 1. Two small holes where downlights were placed 2. Air con duct that will be removed Looking for someone to patch and sand. We will paint it once dried

One wall approximately 7.5x3m to be rendered. Looking for a lightly textured finish Either white or dusky pink pre tinted.

Kitchen renovation has meant light fixtures have been moved in kitchen ceiling leaving holes. 6 small holes (4 x 90mm; 2 x smaller) need patching and then painting. Will need to be able to match paint from existing ceiling.

Just remove a power point in a gyprock wall / terminate - pantry to be installed over

Hi I have a few holes in the walls that need filling. Around 5/6. Am in The Gap. Please only quote if you have a high rating and are not new to Airtasker. Thanks 😊

Plastering surrounded where a bifold door has been installed. 5.4m length. Repairs to cornice required. Trade must supply materials. No painting required.

I need a room walls and ceiling and some wall and ceiling plasterboards tapped and finished and painted. The job got started, but the guy walked away after the first day with full payment.

Current awning has blown off so need a new mesh replaced

I need a room walls and ceiling and some wall and ceiling plasterboards tapped and finished and painted.

We have moved the solar system and need to render patch where it was. Also a bit of patching on holes and tidy up. 1 wall to be rendered ground level.

Require an experienced individual to render one side of the slab in our pool area (cream colour preference). Area is 12m long with height varying from 120mm to 220mm as pictured.

The job is to replace a Fiamma F45 on my campervan. I will purchase the awning, See link below, it also includes instructions on installation. Please ignore the budget, just give me your quote. https://www.outbackequipment.com.au/fiamma-f45-s-awnings-deluxe-grey-size-fiamma-f45-s~14722?utm_source=google&utm_medium=cpc&utm_campaign=21826731768&utm_content=&utm_term=&gad_source=1&gclid=Cj0KCQiAvbm7BhC5ARIsAFjwNHuVy2A7Wn0g4usF6WN4l_-KM6UdUK7A7d57I7l98LznpxLN0at1kjEaAqbeEALw_wcB

I want a basic gyprock wall with painting and architraves to create a media alcove

Render wall 2000x 400x400

Install 10 x Stainless steel balustrade posts to be dyno bolted into concrete slab. With wire to be installed and crimped. Will hire swage press if needed. Install 140 x 42 merbau handrail over the top! This is approx a 3.5 x 5.5m verandah. Hoping to have all products on site Wednesday next week (products ordered and happy to share with tasked selected) with start time in coming week or two after this for anyone interested and available. Thanks Katie.

When our new aircon unit was installed, they had to locate zone controllers so made 3 holes in the wall & ceiling of our laundry. Each is about 30cm by 40cm. Painting the room (less than 3m by 2m optional if plastering is good - I have the paint).

I need the awning to go directly onto the roof racks. I can’t figure out how to do it.

Replacement of 2 bathroom heater, light, lamp Replacement of 4 bathroom lights Replacement of 3 pendant lights (All replacement lights provided) Repair of 1 power point Repair of 1 external light

We are seeking a skilled and experienced plasterboard installer for a small residential project. The job involves fitting plasterboard panels to walls. Attention to detail and a high-quality finish are essential.