Find experienced local tradies in Chapel Hill QLD

FC wall around 3.5m wide by 2 m needs to be rendered only and a triangle above it around 1.5 by 1.5 high . This is part of the facade that’s already rendered but these are added components that need to match.

Hi, I need a licensed electrician to: Disconnect and remove my existing hardwired electric cooktop. Install a new power point inside the cupboard underneath for a gas cooktop ignition. When quoting, please confirm your availability and include your licence number. Thanks!

Removal of the old dirty shade cloth, Replacement with a 6m X 4m shade cloth (supplied)

Just need new GPO installed, existing one not working due to age. Have the new one here so literally just the labour.

Rendering an outdoor block wall so we can paint it

I have purchased 3 awnings online and would like them fixed/installed over the windows of a brick home.

Looking for a licensed electrician to disconnect and remove a power point in our backyard

setting/plastering in old doorway and wall reno. in small unit.

Built in wardrobes needing relining / plastering. I want the backs and sides done with cement sheeting and the ceilings to be done with gyprock aquacheck. I have all the cement sheeting and aquacheck needed. I have cement screws and plasterboard screws, a big bag of base coat 45 and joint tape. I need someone to install and get these all done and prepped ready for me to paint before I get new wardrobes installed. Approx measurements: Linen 2370mm long 2460mm high 440mm deep Bedroom 1 1650mm long 2460mm high 540mm deep Master bedroom (need all done except one section needs to be left open for structural work 3700mm long 2460mm high 540mm deep

I need plastering for some interior walls - end of the day and weekend works well

I need someone for rendering - can be end of the day or weekends. Some walls are interior and others exterior.

i require a professional clean and seal of glazed tiled verandah 13m x 3m

Three existing Canvas Dutch hood awnings need to be removed (as in the left picture), and 3 new factory buys polycarbonate awnings need to be installed (as in the right image). A ladder will be required to reach, remove and install the awnings.

Need plasterer by the hour to put up the ceiling plasterboards and patch properly so the surfaces are ready for paint. $40 an hour, minimum 4 hours, could take up to the whole day. Gyprock boards will be provided. Come with your own equipment though.

I want to build two walls with Gyprock, sized 2.5 m x 60 cm and 70 cm x 210 cm." Feel free to ask if you need further assistance

I would like a new induction cooktop installed and to have two PowerPoints in the kitchen replaced

I have some damage to a gyprock wall about the size of 30x25cm. I Would like it mended

Patch up 2 x Intercom holes - ready for painting (I will remove the inter comes)

Looking for someone to rendering some part of the wall that it looks uneven.

Hey, Happy to pay for skirting, gyprock, etc needed for the job. Looking to get some help to properly finish this bedroom off. Went the DIY approach when moving in to remove a broken old wardrobe, but it's become a bit of a mess and need to get it done properly as we're keen to move our new baby into the room and start making use of it. Looking for: - Drywall ready for painting. Potentially ripping out all the drywall to put in insulation pads inside? - New Skirting boards / Cornice - Floor repair. Some unfinished from where the wardrobe was, along with a hole in the flooring. There's also scuffs on the floor which would be ideal if there are options to clean it up. Appreciate the time to review and quote, Cheers,