Find experienced local tradies in South Brisbane

Rendering of understairs storage room internal brick walls + ceiling. The half-height area is roughly a 2.5x2.5 meter square, and the remaining hall has about 1m of unfinished brick lengthwise.

Hi, I’ve just bought a Kings Plus 170° awning and I need someone experienced who can install it properly and safely onto the roof bars of my Pajero Sport. A few photos to give you an idea.

Change existing light switch and power point to new (switch and PowerPoint supplied).

I would need a plasterer to help with a few patch ups (medium / large cut outs) in the interior walls. Details as follows: 1) Patch hole left by Wall RAC aircon that was removed 2) Patch hole left by Electron TCM-600 Celebrity that was removed + 5 room stations

Replace the hall balustrade due to wood rot

We need a window awning removed from the second story of our home. Needs a long ladder as it's quite high up, with the driveway (hard concrete) underneath. The awning is one of those old retractable ones but the mechanism has broken so it cannot be moved/retracted from inside the house. The awning frame is metal so has a little weight to it. The holes will need to be filled/patched once removed.

A wall hole size 200mmx200mm

Due to rain water seeping in, the render outside the balcony area has cracked and started peeling off. Need a rendrer to repair and render the damaged areas as shown in pictures. Needs a solution so that water doesn't seeps in again.

I have about 150m2 of walls and ceilings that need sheeting and finishing. Hourly rate preferred.

Install the attached curved awning/canopy above my outdoor solar battery . The awning is already purchased — just needs mounting. Details: Battery is installed outdoors on the brick wall Awning dimensions: approx. 155 cm (W) × 81 cm (D) Wall is accessible with clear working space

Box out door and replace with gyprock wall. We don’t need a doorway and we are closing it permanently, see pics attached. Task is to supply and install timber and gyprock to form a wall flush with existing. Install skirting as per existing. Plaster as required.

Involves sanding kick boards, plastering and gap filling the balustrades and stairs. Cleaning the drops of paint on the stairs. Roughly 15sqm of wall to paint as well. Paint will be supplied by me.

Install 2–3 standard power points. Existing power nearby. Easy access.

Hi, I accidentally clipped my rendered mailbox and need it repaired. Scope of work: - Repair chipped render (foam visible underneath) - Match existing texture (important) Colour match paint - Re-level / stabilise mailbox base (slightly shifted) Notes: - Standard foam/render mailbox (not brick) - Looking for a clean cosmetic finish so damage is not noticeable - Flexible timing but sooner is better

Need to render outside of new door that was installed in a brick wall going out to a new deck. If we can render the door frame flat, then we will paint.

Roofing/flashing repairer required to inspect and repair water ingress issues in 3 areas of a house/carport. To address the source of water ingress, reseal/waterproof the affected junctions, and replace any locally damaged fascia/trim where required. Large-scale replacement works are not expected unless clearly necessary. Part A – Carport corner/pillar Water appears to be entering the corner above the brick pillar, causing the black fascia/trim board to rot, with staining/runoff down the pillar. Required: Inspect and identify likely entry point Carry out targeted resealing/waterproofing of the junction/flashing Remove and replace the damaged section of fascia/trim if needed Make the corner watertight Part B – Front awning/patio roof Leak where the metal awning roof meets the house wall. Required: Inspect roof-to-wall junction Reseal flashing/joints as needed to stop water ingress Part C – Rear awning/patio roof Similar issue to Part B, but along a longer section. Required: Inspect leak points Carry out targeted resealing of flashing/joints as needed Ensure water is draining away correctly Photos attached. Please quote for the repair work needed to make the affected areas watertight. If any larger replacement works are considered necessary, please explain why and provide that separately from the base repair scope.

Correctly plug hole with plaster and small paint over 50cm x 10cm strip where old light fitting used to be

Fix up a bit of plaster work and paint after. Only ceiling of main bathroom and ensuit.

Need a handyman to fix, sand and paint two small holes on the plasterboard wall.

I need to put 5-6 power point