Find experienced local tradies in Parramatta

Motorised retractable awning at a side window not responding to the wall-operated manual handle. No visible external damage to the fabric, arms, cassette or switch. There is no sound or movement when attempting to operate the awning.

I am looking for a licensed electrician to inspect and repair a faulty power point used for my dishwasher. Issue: The power point switch does not turn off and appears to stay permanently on. What I need: Diagnose the fault. Repair or replace the faulty power point/switch if required. Test the circuit to ensure it is safe and working correctly. Please let me know if any additional parts are required before replacing them. Requirements: Must be a licensed electrician.

To replace 4 Double Power Points, as they have stopped working. I can provide the replacement parts, and the task is only for labour cost.

Experienced renderer wanted to come onsite and inspect front brick fence for acrylic render job. South Granville

Looking for a renderer . On going work for the right person.. Thx

0 Recently removed old concrete railings want aluminium white finish railings installed have $3000 only budget

2 small holes need plastering. See attached photos with measurements

Hello, I am looking for an experienced Wet Plastering specialist to repair a damaged cement render wall in my double brick home. This wall surrounds the sliding door to our backyard and consists of 3 sections (left, middle and right). The work includes: * Repair and re-render the wall, leaving it ready for painting. We know that an experienced Wet Plastering specialist has the skills to achieve a finish that blend in as naturally as possible with the existing wall. That's why we'd love to have the work carried out by a professional rather than doing it ourselves. * Repair the gap between the wall and the concrete floor using appropriate materials on the left side section. If you notice any underlying issues, we'd really appreciate your advice before proceeding with the repair. Thank you very much! We look forward to hearing from you.

We have a new 65 inch TV. Have also purchased a full motion TV wall mount MD2617-24K-04 which is compatible. After someone to install the wall mount and mount the TV onto drywall

Need some patching done on some plasterboard photos attached

I have two drywall patches that need patchwork and paint afterwords. Both patches are 3-4cm in radius.

*9am Friday Morning The sauna is brand new. The heater and light connects have been mixed and need swapping and made safe. Our assembly guys will meet you there

I want to change the cover of power point

Ceiling gyprock replacement / repair works. There are total of 4 areas that require replacement which includes replacing damaged 90mm cornices as well. Living room 1. Replacement of ceiling, approx 10sqm 2. 90mm cornice, approx 12lm Bathroom 1. Sand and patch 2. Paint Kitchen & laundry 1. Replace cornice, approx 3lm 2. Patch and sand 3. Paint Common area 1. A frame ladder and planks (no scaffolding needed) 2. Replace cracked ceiling+ cornice where applicable. 3. Paint Note: Floor protection on all areas is a must and clean the site after completion.

Hi please gyprock and plaster prep ready to paint. You'll need to bring plaster sheet. About 2 m x 1m

Looking for a local licensed and insured electrician to submit an offer to replace the attached broken 3 phase wall power point in a commercial kitchen on Church Street, Parramatta. Offer should include all costs including supply please.

Looking for an experienced handyman or insulation installer to replace damaged ceiling gyprock and install foil insulation under the roof (as per attached photo). Scope of work: • Remove damaged ceiling gyprock • Supply and install new gyprock/plasterboard • Tape, set, and sand joints (ready for paint) • Install foil board / sarking insulation under roof rafters (like existing in photo) • Secure insulation neatly between timber framing • Re-inforce the rest of ceiling and set finish. Clean up and dispose of waste

A section of plasterboard has sagged/collapsed. Remove and replace damaged plasterboard or reuse if possible. Tape, set, sand, and paint to match the existing matte white ceiling finish. Reinforce the area (joists or fixing points) to safely support the existing curtain track and heavy curtains – suggestions welcome. Care needed around recessed lighting, air vent, and window/curtains. All materials (plasterboard, compound, tape, paint match, any reinforcement timber/screws) to be supplied by the tasker. Clean up required – vacuum dust, protect floors/furniture.

Need one external power point to connect wall fan on the deck Nearby points are garage, backsideof the wall is kitchen switch board boards Brick wall outside

Hi, I need to hang two wall mounted hangers (per photo). I’m after someone that can detect the wood behind gyprock so the hanger is drilled into wood, not just gyprock.