Find experienced local tradies in Leichhardt NSW

Someone needs to close the gap between the exhaust system and the wall that we have with some drywall.

I somewhat stupidly decided that anchor plugs in gyprock would be strong enough for a mounted TV arm, forgetting about the power of leverage with the arm extended. As a result I need the damaged gyprock repaired / patched (dont worry about painting) Also I need the tv mount/arm reinstalled - there is a gap in the studs where it needs to be installed, might need a piece of wood screwed in to bridge the gap.

Replacement of led light switches and PowerPoints, materials supplied, approx 15

Supply and install a new outdoor PowerPoint toward the front of our property on an existing circuit . House is weatherboard.

We have a power point which has come away from the wall. We need it repaired so it's back in the wall. The power still works we just need the the power point secured and the wall repaired a bit. We don't need it painted just secured and patched etc.

I have a freshly built outside wall that needs rendering on both sides. It's about 3m by 0.8m tall. Also render repair of a small area of the house wall about 60cm x 60cm. Based in Leichhardt. Painting not needed.

I need to replace the tent on my awning

Render bathroom walls and have ready for tiling

We need a balustrade to go around two sides of an outdoor landing (pictured). Total length is 2.3 metres with one right angle. All on level brickwork. Ideally it would match S/S balustrade (pictured) but different materials would be considered.

2.4m x 1.4m wall and small portion of ceiling and corner on left hand side, where the downpipe is located (see photos) to be replastered/gyprocked. Small tiled area to be removed too. Current water outlets will be moved to 50mm above floor - near drain, prior to this job. Paint and cornice not needed. Job to be completed prior to Friday 29th lunchtime, but preferably on Thursday 28th

Water damaged part of ceiling gyprock sheeting needs patching. Corner of ceiling about 1.5m x 1.5m

Move and refit existing built in wardrobe. Extend it to fit new wall length by 1 metre

Require my hair tools tagged for a job this week 5x Ghd 1 Dyson hair dryer by electrician job on Thursday I know budget isn’t huge but had them done before and only takes a few minutes each - happy to give you a hair cut as good will

Old shed (now demolished) had a 240V supply underground in a steel pipe. Currently isolated at source. We want an outdoor double power point attached the fence fed from this existing cable. I.e. In the marked up photo some sort of underground junction (green), cable and conduit to fence (yellow) and supply power point (red).

Replace approx 600x1700mm section of plasterboard ceiling, cut around chimney. Supply and fit approx 4 linear metres cornice along wall around chimney and/ or replace cornice around entire if existing can't be matched.

Render brick walls Approx 3.4m each side and 1.2m other side 85cm high

We need the gyprock shaved back square at the front to fit 20mm stone on the carcus.

Build a wall, install a regular door, paint it to match the surrounding wall. The length of the wall will be around 13 ft. Supply and install framework,supply and install gyprock sheets,plaster joints,sand and paint wall colour of our choice and(optional) install standard power point for fridge. In the end supply and install standard door jam and door with arcitraves. - Due date: Before Friday, 1 March 2024

We'd like to remove or render (open to other ideas!) the slate tiles on our fireplace feature wall. Ideally we'd like to return it to a plain white wall. We're pretty sure there are bricks underneath and the current slate tiles have been glued on. We're open to removing them completely, or another solution if there's an easier way to cover them. - Due date: Flexible

Need a power point installed - Due date: Needs to be done on Thursday, 14 December 2023