Find experienced local roofers in North East Perth

Remove old guttering, Keep centre gutter that leads to soak well, sealed on both sides. Replace rest with paver slabs.

There is a small leak in the roof that’s caused some mould on the ceiling

Noticed cracked eave panel. Unsure of cause House will be selling soon, want to repair first

I need an approx 2metre section of rusted gutter replaced. In woodland grey if possible. And a connection between a gutter and downpipe replaced.

Car roof lining repair in VW Tiguan 2010 model, no sunroof.

Three by one single storey house. Cement roof tiles. Paint has worn. Roof tiles need a pressure clean and repaint.

Looking for someone experienced with welding/fabrication to help build a custom DIY roof rack for my Jeep Wrangler JK (soft top). I want a clean, practical design and I’m open to ideas. Ideally looking for someone who can help with design, fabrication, and installation. happy to discuss cost depending on experience and setup. Located in Perth. Flexible with timing.

Gutter flashing to supply and install

Install batts in my ceiling r 6 rating. Bring ladder, measuring tape, boards to kneel on in the ceiling.

Hi i would like to get our roof redone completely and want to get quotes for the same

Well both the hinges on my roof tent have been bent due to impact damages. How can i got about getting it straightend, out so i can open it and check other damages. Basically the 2 hinges on the drivers side are bent. 1 of the support beams for the tent is cracked too. Please see the pictures attached? And how much would a repair go for?

Relocate down pipe to make way for a larger sliding door. Connect down pipe to existing piping under the bricks. Close and seal original gap in gutter.

Install 2 x sheets of clear Corrugated Polycarbonate Roofing approximately 700mm wide x 2000 long in 2 locations on an outside patio. Will need to bring all tools, fixings, materials and ladder. Will need to be careful that existing sheets are not damaged. Waterproof if necessary. Materials <$100 Thanks

The transparent corrugated roof sheeting above our elevated deck needs replacement, either like for like, or by light weight metal sheeting. The roof are area is about 5m by 4m.

A roof tile(s) has either slipped or broken, that needs replaced. I have spare tiles

Hi, I need a single roof flume installed on a colorbond roof (25 degree pitch) to connect an exhaust fan from our ensuite. You will need to provide the flume, flashing and silicone. The fan already has flexi duct attached, just needs to run to the flume

We have our own paint and 3m high ladder provide (recommend if you have your own and higher). I need someone to do the painting 2-3 m long, 10cm width gutter. The grey area in the photo circled. Should take less than 30 mins

Needing roof tiles replaced Looking to get quotes Photo just showing where solar will be in future. No solar currently I have the new tiles which are the same size as old ones Tiles are easy - only ones that need to be cut are in half as it is a straight roof My partner will be able to assist if required Price negotiable

Lounge room windwos are allowing water to come in, need to clear the are around the windows & lay down a barrier. Plan is to rake back, support with brick and backfill with blue metal or similar.

I need assistance reconnecting my kitchen rangehood ducting to the existing exhaust flume on the roof. It was previously connected but has recently come undone, and now requires proper reattachment. The rangehood and duct are already in place, so the job is mainly ensuring a secure and sealed connection to the roof flume. Looking for someone experienced with kitchen ventilation systems who has the necessary tools and safety equipment to work on roofs. Please let me know your availability, experience with similar jobs, and any questions about the setup.