Find a professional gyprocker contractor in NSW

Fix hole in wall and skirting board - gyprock job 30ml hole to cover a light switch and 2 x damaged 100ml by 50ml on skirting board

Hi. I need the gyprock of this area of the bathroom fixed. I had a towel hanger prior, but broke as my daughter pulled on it. Require the area to be carved and replaced with a small piece of gyprock (which i am able to provide if required). Do not require the area painted just a well flush job of gyprock.

Need plastering done with minimum dust

As per attached photo. Need repaired with a new piece. 40 cm by 40 cm Only sanding done ready for painting..I can paint

Few holes in gyprock walls to be repaired . One large hole and few small ones

I need a gyprocker who can install damaged front hall ceiling 270 in height, with width 210, length 720 Including standard concave cornice. Painted white to finish. See photos for damage.

Gyprock wall 2100/3300 with 3 corners needs jointing. Corners are done and It is ready to go now, access would be 6am to 12pm.

Looking for a professional licenced handyman, plasterer, or gyprocker to repair a small section of ceiling in my attic that was previously cut open to install a smoke alarm. There is no ongoing leak or water damage. Job involves patching the ceiling and sanding it smooth so it looks neat and tidy. No painting required. Small, straightforward job. Photos attached.

Super quick job - my tools are in storage Just need one 8-10mm diameter hole drilled through an internal gyprock wall - so I can run a small hose through it (wall approx 75mm wide) Power point availalbe if your drill needs Easy access to house (park in driveway) You'll be in and out within 5-10 minutes

Hi, I need a really good gyprock repairer as this whole is in my main light room and the sun light hits it, So I need a really good, experienced person. The whole is around 20cmx20cm. I need it repaired and then I'm happy to do the top coat to get it level and smooth.

(1) I have some ceiling holes made by an electrician that need to be patched (I have the pieces of gyprock), and a couple of smaller 10mm drill areas (2 through plaster and 2 through brick) than need to be filled with an appropriate filler. And then painted as below. (2) There are a few small patches around the areas of the holes that have glue on the wall and/or paint ripped off from previous ducting that needs sanding back/off, then painted. (3) I will provide ceiling and wall paints for you to paint the affected areas once patched. See photos. The ceiling at the highest point where most of the holes are is 3.6m. One of the areas is under a stairwell, which might be reached by a stair-compatible ladder or possibly from the stairs at the same level on the other side. See Photo of stairwell. This is a residential property, there are no access issues, it is my home. Parking: There is no dedicated parking, I can provide all-day street parking permits. Usually it does not take long to get a park during a weekday.

Finish up this wall for a cleaner look with a plasterboard cover and white paint (lexicon half). The wall is ~240x150cm minus the washing machine hole.

We had a leak and have replaced the pipes. Now need to gyprock the roof to patch it up, but I would also like you to install a hatch for access in the future. Would likely need to come and size it up, then go to binnings to get the right hatch.

Need a few ceiling tiles changed in an office space.

Need a gyprocker to quote on patching this hole in a bedroom in Menai thanks

Ceiling gyprock replacement / repair works. There are total of 4 areas that require replacement which includes replacing damaged 90mm cornices as well. Living room 1. Replacement of ceiling, approx 10sqm 2. 90mm cornice, approx 12lm Bathroom 1. Sand and patch 2. Paint Kitchen & laundry 1. Replace cornice, approx 3lm 2. Patch and sand 3. Paint Common area 1. A frame ladder and planks (no scaffolding needed) 2. Replace cracked ceiling+ cornice where applicable. 3. Paint Note: Floor protection on all areas is a must and clean the site after completion.

Hi please gyprock and plaster prep ready to paint. You'll need to bring plaster sheet. About 2 m x 1m

Description: I need a ceiling skylight (perspex/light panel) fully covered and closed off using gyprock. * Located above a stair void (double-height, difficult access) * Skylight currently lets light through — I want it completely sealed and finished as a normal ceiling * Area is visible, so finish needs to be clean and professional Scope of work: * Remove or cover existing skylight panel (advise best approach) * Frame as needed to support gyprock * Install gyprock to close off opening * Full plastering, setting, sanding * Paint to match existing ceiling * Ensure smooth, seamless finish with surrounding ceiling Access considerations: * Located directly above stairs → ladder/scaffold setup required * Tasker must bring appropriate equipment for safe access Requirements: * Experienced gyprocker/plasterer (carpentry skills a plus) * Must bring all tools and materials * Clean finish expected (no visible joins) Budget: * Expecting around $500 (hearing offers), depending on access setup and complexity * Open to quotes if additional work required (e.g. framing), but explain upfront Timing: Flexible, ideally within the next 1–2 weeks Photos attached for reference

Gyprocker to base coat and top coat existing ceiling water damage

Mount 2.4m whiteboard to gyprock wall. Need to supply butterfly clips and screws. I can help with holding it while we mount it. There are holes in the whiteboard frame for easy mounting. Mount small towel rack to gyprock wall. Need to supply butterfly clips and screws.