Find professional cornice repairs in NSW

Removing cornice from ceilig very easy to come off just stanley knife and rip

I already started. All you need to do is pass over the cornice with Stanley knife and rip off

Single cornice needs to be replaced. On a raked ceiling needs to be a professional plasterer

Add missing cornice piece and replace portion of damaged wall

Plaster cornice installer required for approx 60 sq metres

I need someone to repair damaged bathroom ceiling plaster cornice around the ceiling manhole/access hatch. And a skirt board corner in lounge area

We have removed the old Cornice from our unit. We need someone to come and plaster the wall and side of ceiling in and smoothen it out for a smooth and clean finish As we do not want to replace it and leave it bare, it is approximately 100 mil on the wall side and 100 mil on the ceiling side. Total length approximately 35 meters Old cornice will already be removed throughout as well as cleaned up

Need to replace two pieces of cornice. Area has been prepared. Old pieces gone. Both about 1 metre. Have all materials already. Just need someone to get them up.

Part of our cornice in the bathroom (around 1.5 metres) has fallen off. We’d like it reattached.

2 m cornice and a small kitchen wall to be painted. Paint will be supplied.

We have 2 metres of cornice that needs to be installed above a closet.

Re-attaching a fallen cove cornice piece in picture . Clean old adhesive, applying new adhesive (like cornice cement or construction adhesive), and supporting it while it sets prefer no nails as I don’t want to repaint Its in one peice so should be easy to re glue

Plaster 16sqm of fyrecheck and install 10m of cornice. Only requiring setting of the fyrecheck. Will be ongoing work at different locations. Send your sqm rate.

Supply and install gyprock sheets to garage ceiling and supply and install cornice around. Must make it ready for painting Size of garage is 2750x8500mm and about 2100mm high

Looking for a plasterer or handyman to repair a corner section of cornice in a bedroom. The Job: > * Remove damaged section and install new 90mm Cove Cornice. One side is approx 18cm, the other is 27cm. Tasker to supply the small length of cornice and adhesive. Need the joins set and finished so they are ready for me to paint later. I have attached a photo showing the damage and the 90mm profile. Please let me know if you have any questions!

Install approx 18LM of 90mm cove cornice. internal corners = 7 External corners = 6 End infill = 3 Material supply and install to be agreed on Note walls and ceilings may not be flat, level or plumb.

Bathroom walls and ceiling lining

Cornice has bubbled up. As pic. One cornice is smaller than the other

There is a small gap in the cornice where air conditioner ducting was removed. I can purchase the cornice from Bunnings. I need it to be cut and installed and gaps filled.

I have a few walls that needs joins plastered . I made a start on some (didn’t do a great job) and have sanded them back. Also need a few bits of cornice to go up. See photos. Get it to finished stage ready to paint.