Find experienced local carpenters in Armadale VIC

Hi. I’m looking for an experienced carpenter or handyman to build and install a strong shelf above a washing machine to hold a 56kg heat pump dryer. The shelf must safely support at least 80kg to allow for vibration while running. The space is inside a bathroom and has tiled walls on three sides. The dryer cannot sit directly on the washing machine as it would block a light switch, and we’d like a small gap between them for storage. Photos and measurements are provided. Needs to be secure and professionally installed. Thank you 😊

Few jobs: Add an extra section of wood (supplied) to an outdoor studio railing to make it safer. Extend rail on stairs to go the full length. Timber supplied. Screws in hooks on walls and attach strip to bottom of door to close gap.

I need a section of my kitchen cabinetry replaced due to historic water damage (the leak has been fixed). Scope of work: • Remove existing damaged under-sink cabinet and adjacent cabinet to the left • Install owner-supplied flat-pack cabinets (Bunnings or similar) • Ensure cabinets are level and securely fixed • Prepare cabinets for benchtop installation (benchtop install may be separate) • Leave plumbing disconnected for a licensed plumber to reconnect Details: • Apartment kitchen • Partial repair only (not a full kitchen renovation) • Cabinets are standard laminate / fibreboard flat-pack • Looking for a handyman or carpenter experienced with flat-pack kitchen installs Quotes only at this stage.

Front door has gap across the bottom requires a piece of wood to be nailed on and then painted. A strip wouldn’t work as well as the gap is about 10cm

My closet is currently all hanging space. I would like shelves to be built in half of the closet (likely 5 or 6 shelves) with a height appropriate for small items (towels, sheets) and shoes. Measurements included in photos. Shelves appearance should mirror the current closet materials.

Need a new kitchen, keen to understand costs and get a quote. Site access tomorrow.

Sand/stain floorboards for 2 units. Include kitchen area which is lino that needs to be pulled up - need to come to site tomorrow ideally and provide a quote

Looking for someone to: - Pressure clean decking - Apply deck rejuvenation solution - Prepare decking for coats of deck finish (Walnut tint preferred) - Apply the same process to outdoor furniture: 1 table, 2 benches, 2 chairs and 1 sun bed Reliable and detail-oriented applicants only. Tools and materials must be provided Measurements in photo provided

Build x 5 shelving units for a storage room @ store in Armadale. Minimal tools needed. https://www.templeandwebster.com.au/Herman-Garage-Shelving-Units-DWHO2722.html?refid=TEM_WF_262&mmid=133068401&csnid=8CD25136-0859-48F9-8B72-42CE3C823ED9&cltr=&utm_source=Temple-Webster&utm_medium=email&utm_campaign=OrderConfirmed&utm_content=pdp&utm_term=pdp

I need to get a framework done approx 7 metres long and 2 metres high with 4 anchor points to hold sheer curtains in a commercial space.

The hallway and family room that is what i would like done

We need a carpenter to finish off completing our bathroom door frame and wall skirting at our cafe. Materials provided. See photos attached.

I want yellow stain to be removed from my carpet

Hello, I need a cabinet made for my restaurant in Armadale. I’d like it done in Walnut. I need it done within 2 weeks. Drawings attached below

We need a carpenter to build/construct a service bench at our cafe which food will be placed on. The Bench will need to be 75cm long and will need to “swivel” out of the way outside of service hours (see photo 1). The existing door will also need to be cut so half can open during service hours. Please quote including materials.

Sand back floor boards & stain with feast Watson stain.

Small outside deck sanding and staining (restore to original condition) including built in timber seating. NOTE: Deck has screws Deck and seating needs to be sanded back to original condition with current stain removed. Must have own equipment and experienced sander Approx 15sqm

I need a cabinet maker to make kitchen cabinets , laundry cabinets and wardrobes for a full home renovation project

Need a table and bench sanded back and re-stained. Must have electric sander Stain colour to be as similar as floor as possible.

The nail of the bed is coming out regularly which is affecting the bed and not able to sleep properly.If you can fix the nail with glue or something that would be really helpful