Find a reliable appliance technician in Malvern VIC

Freezer door not closing properly, seal appears damaged, it is regularly icing up

Install benchtop device. Likely need to either replace existing tap or connect to main supply. Thanks

Pilates machine not working properly, need it gone.

Removal of old and installation of new Westinghouse Gas Stovetop.

Needing my dryer serviced. It is a heat pump fisher & paykel dryer, about 4 years old. It has started making a very loud noise when in use.

Removing a screwed on cap from the pipe to connect the washing machine

Currently dryer is mounted in laundry may require 2 people- remove and leave for next hard rubbish removal

Fisher and Pykle DishDrawer on/pause button jammed, so unable to start the dish washer

I need a certified gas plumber to install 2 kebab machine and one fryer to my kebab shop. There is also a gas line I have attached the photo as well.

Seeking specialist in fitness equipment to de-install a Bodycraft Xpress cable machine. Access at location requires machine to be taken apart almost completely. Transport to new location about 1km away. Re-assemble and install at new location. No access issues new location. Looking for experienced fitness equipment movers with cable machine experience.

Bosch Series 8 washing machine displays ‘tap’ fault light.

I am looking for help to connect my Bosch Washing Machine to a new rental (photo attached) and would be grateful for someone to help connect it. Thank you, Jess

I need to have an existing gas pipe extended about 1m to enable its connection to a new dual fuel stove. It will have to come through a single brick wall and a porcelain tile.

Smeg dishwasher isnt closing. Appears to be something wrong with the latch. Electrics work still.

I need a new dedicated power supply before I can get my new dual fuel stove installed. The cabling will have to be as discreet as the circumstances permit and yes the switchboard has recently been upgraded.

Hi, We have a fisher and paykel2 drawer dishwasher that needs to be installed in the cabinet under the bench. We need the cabinetry fixed and the dishwasher fully installed (including the plumbing). The doors need to come off, shelving etc taken out. Place made for dishwasher to be installed and then in the 170mm space between dishwasher and wall, we need an additional cupboard to be made to match the rest. It's a small kitchen so we need to be smart about every cm. I have found a pull out cupboard contraption that can be ordered and fitted, with the cut down door stuck on the front. I just need advice on which width and depth to purchase. We will also need a short extension cord to go from the dishwasher to the adjacent cupboard where the power point is located. In addition to this, we'd like one shelf made and installed in the hall cupboard so that we can relocate everything from the kitchen into the hall.

I’ve just had a new kitchen done and need dishwasher connected.

20yo Kleenmaid (Speedqueen) washer. Don’t want to throw it out. Needs new hose and spin does not work properly. It’s intermittent. New controller installed a couple of years ago. May be a belt or drive that needs repair. Also needs new hose and connector.

Hi, I need someone to look at a Hunter sprinkler system, diagnose if any issues, repair and program until its on. Before Friday 7th please.

12 month old V Zug dishwasher has developed a squeaky door when opening and closing the door