Find a reliable appliance technician in Carnegie

It’s a Haier dryer, spins in 2 directions. Makes weird noise when spinning in 1 particular direction only.

Replace existing canopy rangehood with a new Mistral 90cm Canopy Rangehood MBRC913-7X including Flue Extension. Electrician's licence required. Easy install - no cabinetry, tiled splash back. Dimensions of replacement match existing install. Ducting already in place.

Dishwasher and bath is blocked so they need to be cleaned somehow. Dishwasher leaks when on so assume there is a blockage. Bath is slow in draining.

My dishwasher stops when I start a cycle, and beaps a lot, and that's it, AEG brand, about 10 years old. My oven burns without cooking and gets a tough smell of gas pretty quick. If you cannot repair both, I will also review quotes to repair one of them.

Install integrated dishwasher between the sink and oven, dishwasher is from Ikea

I am building a new kitchen and need a power point for microwave cupboard, 2 new power points on my wall (it is concrete so would run on top of the skirting board) and connect an induction cooktop, attached is the kitchen and wall

Decomission Gas Cooktop as I am getting a kitchen

Looking for someone to remove this component or modify as it keeps breaking when opening the cupboard. Looking for a basic modification.

Hi, we have two electric sit-to-stand desks in our office that need repairing. There seems to be a wiring issue where the motor is no longer responding and the desks will not raise or lower / stuck in position. The desks are an older, unbranded model, likely imported, with a fixed beam through the middle. We haven't been able to identify the make or model, and the suppliers we've contacted couldn't help. Looking for someone with experience repairing electric sit-to-stand desks (motors, control panels, or legs), or someone who can identify the model and source replacement parts. Details: Number of desks: 2 Location: Carnegie, Victoria 3163 Access: Ideally a Saturday would be best. Otherwise during office hours M-F between 9am to 5pm. Photos: I'm happy to send photos of the desks, controls and underside for a quote. Please message me with your experience, availability and a rough quote. If you think the desks can't be repaired, I'd still appreciate your opinion on why.

I just need someone to lift the dryer on top of the washing machine.

We have a Bosch 8 series washing machine. Lately water has been leaking (we think from The filter) during wash. If we drain the water after each wash, it’s okay . We need someone to get this checked and fixed

Bought a new rubber insert and finding it hard to fit it properly. The concrete blocks in the washing machine might need to be removed (just needs a wrench). Bonus if you can also fit the spring back on too but we can do it.

Dishwasher not working, unsure why

The dishwasher has water at the bottom after a wash. It’s used as normal, and when the cycle finished, I opened it and all the dishes were clean. The only issue is that the water didn’t drain away, so I think it’s just a drainage problem. I’m looking for someone experienced with dishwasher repairs to fix the drainage issue and clear any blockage if needed.

My dishwasher’s door alignment is not right. Need to get someone to have a look.

Breville Dual Boiler BES920 home coffee machine needs servicing and possible seal replacement or repair. Does not build pressure in the hot water.

Slow valve leak when dishwasher is run - looks like it needs to be replaced based on age

Miele dishwasher G1173SCVI start operations, but then beeps and stops. Water build up. Restart cycle and water drains but then 5 minutes beeps and stops again.

AEG dishwasher needs repairing/unblocking. About 3 years old. Error i20. Runs fine but won't drain at the end. Ideally Sunday morning before 12 or Monday morning

Drum rollers are noisy on my Electrolux EDH803BEWA. I need all 4 replaced. Quote for the labour and let me know parts cost.