Find a reliable appliance technician in Camberwell VIC

Please provide contact numbers through my email Thanks

Kitchen dishwasher fixing

See picture attached. Requires some fixings

Current cook top model is Bellini BDC906OTG. Would like to replace with BOSCH PKM875DP1A Series 8, 80cm. Need an electrician to install as well as making some adjustments to the opening so that the stove top can fit properly. Bench is laminated (not stone)

Becker/oztech motorised sunshade has failed - not sure why. One arm is not correctly positioned, may have struck obstacle. Review and repair

Brand new outdoor gas BBQ in new home is not igniting properly. There is a gas smell when trying to light and seems to heat very briefly but not staying alight. Doesn’t seem to be an ignition problem as can see the spark working when trying to light, potentially a gas flow, pipe or connection issue. I am keen for a gas expert to come and inspect and ideally repair ASAP.

GE fridge with water filter. Connection in the back is loose somewhere - leaks out the bottom when button for water is pushed. Likely needs back off and reconnect, quick job.

GHD Max hair straightener that’s just out of warranty. It flashes red and won’t turn on - I believe it’s a fault in the wiring

We need sometone to repair our Bosch Dishwasher (Model: SMU40M05AU) - the problem started this week when the door wouldn't shut close. We then ran a short cycle and it wasnt able to fully finish the cycle, so there is a small pool of water at the bottom of the machine now. It has been working perfectly up till now, this has come out of the blue. We are based in Camberwell.

Need to modify the cabinets next to the sink to fit a dishwasher - move drawers to next to the fridge (cavity dimensions are the same) - extend the cavity next to sink to fit 600mm dishwasher

Need a steering pump installed and replaced on my 2010 Subaru Liberty

I would like to install my brand new oven.

Hi there, my controller got damaged in the recent heavy rains and is beyond repair. Just need a quote on a new control unit (preferably with backup battery) and 2 new motor arms. Please also let me know the brand you will be recommending. Cheers.

Drill hole in the brand new U-bend plumbing inlet that is still sealed, connect washing machine hose, tighten metal fastener

Install 4 security cameras Install only I have cameras Into restaurant setting

The bottom edge banding on two overhead cabinet doors above the cooktop has warped from heat. The door faces are fine. I only want the bottom edges re edged. Do not quote to replace the doors. Scope; 1. Remove both doors, protect benchtop and splashback. 2. Cleanly cut back and remove the warped underside wrap only, leave the front face intact. 3. Prepare the underside edge, square, clean, and lightly sand for adhesion. 4. Supply and fit new plain white heat resistant ABS or PVC edge banding to the underside of both doors. Use hot melt or equivalent cabinet grade adhesive. No contact film. 5. Trim and flush both faces neatly, radius the arris lightly, seal the ends to prevent lifting, and clean any glue residue. 6. Reinstall and align the doors, check clearances to the rangehood and the neighbouring door, and confirm soft close works as before. 7. Leave the area clean Notes. • The repair is to the underside edges only. The colour can be plain white. A close white match is fine as the new edge is on the underside. • Bring 16 mm and 18 mm white edging so the job can be completed in one visit. Measure on site to confirm. • Location is an apartment kitchen near Camberwell Junction. Photos attached show the exact edges to be repaired. Onsite parking available. Requirements for the Tasker. • Cabinetmaker, shopfitter, or handyman with proven edge banding experience. • Provide a tax invoice if required. Please answer in your offer. Confirm you will re edge only, not replace the doors. Confirm you will use heat resistant ABS or PVC edging and cabinet grade hot melt or equivalent. Confirm your availability and parking needs.

Need to remove and replace broken eaves under front porch, leaving a hole for security camera wires (see photo). Task includes measuring, sourcing and collecting replacement eave. I will pay extra for raw materials.

Moved houses (from next door). Need help disconnecting waterline (see photo) from Fisher Paykel fridge from old house and connect it with new fridge Also need washing machine connection fixed (see photo)

Dishwasher needs slight adjustment to fitting. After tripping on the open door it is no longer flush with the cupboards by approximatley 2mm. Door still closes well and is operational. Experience required with dishwasher installations.

Looking for someone to assemble this Bunnings Mimosa Outdoor Gas Heater. Comes in several parts.