Find a reliable appliance technician in Burwood East

AEG Washing Machine Door Boot Seal exchange, replacing the existing door seal with a brand new one.

Freestanding cooker does not have an anti tilt safety chain installed. One is required to be installed as per AS/NZS 5601.1 Gas Installations - ensuring compliance with Australian safety regulations. Issue the gas compliance certificate for this job

Cap off the gasline to decommission the gas heating appliance. Appliance to remain onsite. Issue gas compliance certificate

Newly bought a bbq Euro Appliances Euro 1200 6 Burner Built-In BBQ with Hood. I have conversion kit. Gas outlet has been. Installed in place. Need a licensed tech to connect the bbq to natural gas. Test working and provided compliance cert.

LG Fridge. Model No GM -F208ST. French Door Handle has come off and wont close properly. Have been made aware the part is no longer made, but if there is a solution around how to seal this that would be great.

The Mode selection button is spoiled and does not work. It no longer clicks and cycles through the selection.

Water leakage in my fridge

Our ASKO dishwasher is not draining properly. There is water remaining at the bottom after a cycle. We haven’t used it again since noticing the issue, so there are currently no error codes showing. We suspect there may be a blockage/clog somewhere in the drainage pipe or filter system, but we’re not certain of the exact cause. Looking for someone experienced with dishwasher repairs (ideally familiar with ASKO appliances) to: • Diagnose the issue • Check for and clear any blockages • Ensure the dishwasher is draining properly again

Hi all Anyone have a horizon treadmill which needs to be repaired. It spontaneously increases the speed and elevation without pressing the buttons.

There are two pipes running in parallel from the meter to the house, see the attached photos 1. cooktop and heater 2. hot water unit. What needs to be done: 1. Cap off a pipe At the copper T junction at the gas meter, cap off the one to the cooktop and heater. (1'' copper tube) 2. Reconnect cooktop and heater to another pipe At the hot water unit(3/4'' copper), add a T junction, and connect cooktop and heater(1/2'') to it. current joints are under the house, need about 2.5m and 5m 1/2'' pipe to connect them.

My SMEG dishwasher (see model number in images) has a broken latch that won’t allow the door to close and therefore it won’t turn on. I need a technician to bring the part with them to the job and help me replace it.

Need to install a Tesla home charger

Hi my wishing machine is running fine but don’t drain the water , the washing machine brand name is BAUMATIC ,

Existing outdoor gas point needs a bayonet installed. We already have the bayonet, if price is good we can also get next door done. Certificate is required as we are renting the property. Only a licensed has plumber will be accepted.

Stacking lg washer and dryer

Gas safety check for a house

Move the cables of security monitor machine to the nearby room

Hello. I have a Haier washing machine. Model number HWT10ANB1. The power button is pressed in and it won't pop back up. Please see photo below. Could you please give me a quota for your service fee and parts. Thank you

Need to install Tesla ev charger, already have 3p set up

Ducted Gas heater not turning on. Thermostat inside the hosue has power, but turning htis on doesn't activate the heater.